614756
21
Zoom out
Zoom in
Previous page
1/120
Next page
19
Thread the guide
A
and then
thread the thread guide (guide in
the circle) for bobbin winding
1
Place the thread spool to the spool
pin.
2
Winding the bobbin thread
* An exclusive motor is built-in for winding
bobbin so that you can wind bobbin at any
time.
Set the bobbin on the bobbin winding
shaft.
3
4
Wind the thread to the bobbin 4-5 times in
clockwise direction.
Put the thread end into the guide at the
bobbin winding shaft and pull it to the
right side to cut it.
5
7
Push the bobbin winding regulator
towards the bobbin to start winding the
bobbin.
* Be careful that the bobbin winding regulator
works as a switch.
6
When winding is nished, the shaft
stops automatically, the bobbin winding
regulator moves to right and return to the
original position.
Remove the bobbin from the bobbin
winding shaft and cut the thread by cutter.
* Bobbin winding will automatically stop even
while winding, when the winding speed is re-
duced due to a load to the bobbin winding motor
caused by thread tangling.
Bobbin winding regulator
Guide (with cutter)
Spool
pin
Cutter
Thread guide
Bobbin
winding shaft
A
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki HZL-DX series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki HZL-DX series in the language / languages: English as an attachment in your email.

The manual is 42,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info