614771
34
Zoom out
Zoom in
Previous page
1/78
Next page
Threading the upper
thread
This is a simple operation but it is
important to carry out correctly as
by not doing so several sewing
problems could result.
- Start by raising the needle to
its highest point, and also raise
the presser foot to release the
tension discs. (1/2)
- Lift up the spool pin. Place the
thread and spool holder onto
the spool pin.
For small spools of thread,
use the spool cap with the
small end facing the spool of
thread. (3)
- Draw thread from spool to the
upper thread guide. (4)
- Guide thread around thread
guide pulling thread through
pre-tension spring as
illustrated. (5)
- Continue downwards on the
right side of the large verticle
thread guide passing under
and up on the left side
allowing the thread to engage
in the check spring as it
passes upwards. (6)
- At the top of this movement
pass it from right to left
through the slotted eye of the
take-up lever and then
downwards again. (7)
- Pass behind the flat,
horizontal thread guide. (8)
- Now take it behind the thin
wire needle clamp guide and
then down to the needle which
should be threaded from front
to back. Pull about 6-8 inches
of thread to the rear beyond
the needle eye. (9)
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki HZL-353ZR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki HZL-353ZR in the language / languages: English as an attachment in your email.

The manual is 29,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info