614558
5
Zoom out
Zoom in
Previous page
1/14
Next page
– 3 –
(1) Information on lubrication
1) Fill oil pan
1
with JUKI New Defrix Oil No. 1 up
to HIGH mark
A
.
2) When the oil level lowers below LOW mark
B
,
rell the oil pan with the specied oil.
3) When you operate the machine after lubrication,
you will see splashing oil through oil sight window
2
if the lubrication is adequate.
4) Note that the amount of the splashing oil is unre-
lated to the amount of the lubricating oil.
When you rst operate your machine af-
ter setup or after an extended period of
disuse, run your machine at 3,000 sti/min.
for about 10 minutes for the purpose of
break-in.
5.
INSTALLING THE THREAD STAND
1
A
B
2
6. LUBRICATION
(2)
Adjusting the amount of oil supplied
to the face plate parts
1) Adjust the amount of oil supplied to the thread
take-up and needle bar crank
2
by turning adjust
pin
1
.
2) The minimum amount of oil is reached when
marker dot
A
is brought close to needle bar
crank
2
by turning the adjust pin in direction
B
.
3) The maximum amount of oil is reached when
marker dot
A
is brought to the position just op-
posite from the needle bar crank by turning the
adjust pin in direction
C
.
1
C
B
1
A
2
minimum
maximum
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki DDL8700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki DDL8700 in the language / languages: English as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info