GLID 118
When the Flap to Elevator Mixing Function is active and a value
for elevator is input, the elevator will be deflected accordingly
each time the flaps are used. The actual elevator movement is
adjustable for both up and down flaps. Thus, the elevator is
used to eliminating pitching tendencies when the flaps are
raised or lowered. This function also includes a mixing offset to
re-define the neutral position of the elevator channel. The effect
of the offset is to change the point at which the mixing actually
begins.
In Function Mode, use the UP and DN keys to select Flap to
Elevator Mixing and access by pressing the UP and DN keys
simultaneously.
Selection of Operation Switch
The switches for Mixing Function ON/OFF and 0 position are
listed below and can be accessed with the + or - keys. When
the applicable switch is in the OFF position, the SW OFF
display flashes in the left upper corner and increase or decrease
mixing value is not applicable. Press the CLR key to set ON.
Differential Value
Normal (0%) Split 100%
(adjustable to 100%)
4.8 Flap to Elevator Mixing (Function Mode)
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
Press the + or - keys to
increase/decrease the
differential value
Press the Clear key to
reset to differential to
factory preset value (0)
To Flap to Elevator
Mixing function
To Aileron to Flap
Mixing function
4.7 Differential Aileron Mixing (Function Mode), cont.
ON Always On
MIX Mixing Switch is Forward
FLP - D Flap Switch Down Position
F - U&D Flap Switch Up or Down Position
