467799
17
Zoom out
Zoom in
Previous page
1/104
Next page
17
4.5 Control of functions
When the product is set up, always check the control functions.
These shall move easily and function satisfactorily.
Jøtul F 370 is equipped with the following controls:
Fig. 29
Air vent fig. 29 A
Pushed in: Closed
Pulled out: Open
Ignition vent, fig. 29 B
Pushed in: Closed
Pulled out: Open
Riddling grate (same handle as for the ignition vent) (Fig. 29 B)
Right handle is pushed in and out.
Handle for door fig. 29 C:
Is opened by pulling handle out.
4.6 Use
Open the air vent and the ignition vent by pulling it out all
the way (fig. 29 A & B). If necessary, keep the door slightly
open. (Use a glove, for example, as the handle can become hot.)
Place two medium sized logs in/out on each side of the base.
N.B. In order to avoid sooting on the glass, it is important that
the log is not placed adjacent to the glass on the product.
Crumple some newspaper (or birch bark) between these and
add some kindling wood in a criss-cross pattern on top and
light the newspaper. (Fig. 30)
Gradually increase the size of the fire, but the wood should
not be stacked higher than the horizontal holes on the back
burn plate. See fig. 29 H.
Finally, place a medium-sized log on the top of the pile.
Place 2 or 3 briquettes or kindling sticks under the top layer
of kindling and light the fire.
NB: The maximum height of the pile of the wood should
be just below the horizontal holes. The holes must not be
covered.
Close the ignition vent (fig. 29 B) when the firewood has
ignited and the fire is burning well.
Check that the afterburning (secondary combustion) starts. This
is best indicated by yellow, flickering flames under the baffle.
Then regulate the rate of combustion to the desired level of
heating by adjusting the air vent (fig. 29 A).
Fig. 30
Adding firewood
Stoke the stove frequently but only add small amounts of fuel at
a time. If the stove is filled too full, the heat created may cause
extreme stress in the chimney. Add fuel to the fire in moderation.
Avoid smouldering fires as this produces the most pollution.
The fire is best when it is burning well and the smoke from the
chimney is almost invisible.
4.7 Danger of overheating
The fireplace must never be used in a manner that
causes overheating
Overheating occurs when there is too much fuel and/or too much
air so that too much heat develops. A sure sign of overheating is
when parts of the fireplace glow red. If this happens, reduce the
air vent opening immediately.
Seek professional advice if you suspect that the chimney is not
drawing properly (too much/too little draught). For further
information, see «4.0 Installation» (Chimney and flue pipe).
ENGLISH
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jotul F 370 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jotul F 370 in the language / languages: English, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info