781062

Joovy Zoom 360 53X Manual

3
Zoom out
Zoom in
Previous page
1/8
Next page
!WARNING
ALWAYS keep children away from the stroller when unfolding.
Possible pinching hazard - Be careful when unfolding the stroller.
5 Front Wheel Swivel Locks
The stroller can be operated with the front wheel in either swivel mode or locked mode.
• To put the front wheel into locked mode, locate the plastic locking lever just above the front wheel.
• Push this lever to the right (clockwise) and rotate the wheel until it locks automatically in the straight position and an audible click is heard.
See Figure 5.1.
• To unlock the front wheel and use it in swivel mode, push the lever to the left (counter clockwise) until an audible click is heard.
7 Operating the Canopy
• To open the canopy, pull forward on the front edge of the canopy until it is fully extended.
• The canopy and visor can be adjusted into several positions ranging from fully closed to full extended, or any position in between.
See Figure 7.1.
NOTE: The top rear portion of the canopy has a roll back window. To open, pull the rear edge up, roll the ap forward and secure using the
T and elastic attachment.
• To close the canopy, push the front edge of the canopy toward the rear of the stroller.
• Engage the two sets of snaps on the underside of the canopy above the seat to allow maximum head room. See Figure 7.2.
NOTE: When you open the canopy with the snaps engaged, these snaps will automatically unsnap.
6 Rear Wheel Brakes
This stroller is equipped with a linked parking brake for the rear wheels.
• Before placing your child into the stroller or removing them from the stroller, be certain that the rear parking brake is engaged.
• To engage the rear parking brake, push down on the brake lever on the right rear wheel hub of the stroller until you hear an audible click.
See Figure 6.1.
• Check that the brake is properly applied by attempting to push the stroller backwards and forwards.
• To release the brake, lift up on the brake lever until it locks into the UP position and you hear an audible click. See Figure 6.2.
!WARNING
Always engage the parking brake when the stroller is not being pushed so that it will not roll away. Never leave stroller unattended, especially
on a hill or incline, as the stroller may tip over or slide.
3 Installing/Removing Rear Wheels
• Take one rear wheel and insert it into one of the rear wheel hubs until an audible click is heard.
NOTE: You may need to push the wheel with some force to get it past the locking mechanism. See Figure 3.1.
• Pull outward on the wheel to ensure the wheel is installed properly.
• To remove a wheel, push down on the metal tab on the rear wheel hub and then pull outward on the wheel. See Figure 3.2.
4 Installing the Front Wheel
• With the stroller still tilted backwards on the handle bar, remove the plastic protector from the front forks and discard properly.
NOTE: rst need to lock the forks into place. See section on “Front Wheel Lock” for this procedure.
• Loosen the round nut on one end of the front wheel axle just enough so that the wheel will slide onto the frame forks. BE CAREFUL that you
do not take this nut off completely. If this occurs, be sure to reassemble the metal washer and spring onto the axle before reassembling the
nut onto the axle.
NOTE: The metal washer must be assembled to the axle with the small metal tab facing IN toward the wheel and the SMALL end of the
spring also facing IN toward the wheel.
• Make sure the safety lock on the opposite end of the axle is in the UNLOCKED (straight out) position.
NOTE: You can assemble the front wheel with the safety lock on either side of the stroller.
• Slide the wheel onto the frame forks being sure that the metal washer is on the OUTSIDE of each fork. See Figure 4.1.
• Make sure the small metal tab on the washers on BOTH sides of the wheel are placed into the small hole in the fork. This is a secondary
retaining method to help prevent the wheel from sliding off the forks in case the safety lock accidentally opens.
• While holding the safety lock in the open position, tighten the round nut BY HAND in a clockwise direction until it is as tight as you can get it.
• Push the safety lock DOWN to the closed position and ensure it is tight. See Figure 4.2. You may need to loosen the round nut slightly to
fully close the safety lock.
• Pull outward on the wheel to ensure the wheel is installed properly.
• If the wheel is loose or able to be pulled off the forks, loosen the safety lock to the unlocked position and tighten the round nut further.
Repeat until the wheel is secure.
• To remove the wheel, rotate the safety lock to the unlocked position and loosen the round nut counter clockwise until loose enough to slide
the wheel off of the frame forks.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Joovy Zoom 360 53X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Joovy Zoom 360 53X in the language / languages: English as an attachment in your email.

The manual is 1.43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info