Manual Joovy Pengdoo (page 2 of 2) (English, French, Spanish)

780396

Zoom out

Zoom in

1/2

PLEASE DO NOT RETURN THIS

PRODUCT TO THE STORE!

If you experience any difﬁculty with the

assembly or use of this product, or if you have

a question regarding these instructions, please

contact our Customer Service Department:

UNITED STATES - Joovy: 1-877-456-5049,

Hours 8:30 am - 5:00 pm Central Time

CANADA - ISSI Inc.: 1-800-667-4111,

Hours 8:30 am - 5:00 pm Eastern Time

NE PAS RETOURNER CE PRODUIT

AU MAGASIN!

En cas de difﬁculté durant l'assemblage ou

l'utilisation, ou pour toute question relative aux

présentes instructions, communiquer avec

notre service à la clientèle:

ÉTATS UNIS - Joovy: 1-877-456-5049,

de 8h30 à 17h, heure du Centre.

CANADA - ISSI Inc.: 1-800-667-4111,

de 8h30 à 17h, heure de l’Est.

¡POR FAVOR NO DEVUELVA ESTE

PRODUCTO A LA TIENDA!

Si tiene diﬁcultades con el ensamblaje o el

uso de este producto, o si tiene consultas

relacionadas a estas instrucciones, por favor

póngase en contacto con nuestro

Departamento de Atención al Cliente:

ESTADOS UNIDOS - Joovy: 1-877-456-5049,

Horario 8:30 am 5:00 pm, Hora Central

CANADA - ISSI Inc.: 1-800-667-4111,

Horario 8:30 am 5:00 pm, Hora del Este

FIRST USE AND ASSEMBLY

To ensure product's hygiene, place all parts in boiling

water for 5 minutes before first use. Always wash all

parts immediately after use. Make sure to

disassemble all components as instructed below

before placing in boiling water or other sanitize way.

To disassemble:

1. Unscrew the collar and take off the handle. (Figure

2. Carefully snap off the cap from the collar. (Figure 2)

3. Pull out the straw from the collar by firmly pulling

on the bottom of the orange silicone straw (near the

straw seal). (Figure 3)

4. Pull out the hard clear straw from the orange

silicone straw. (Figure 4)

To assemble:

1. Push the hard clear straw into the wide end of the

orange silicone straw. (Figure 4)

2. Push the orange silicone straw firmly back into the

collar from the bottom. From the top, pull firmly on the

orange silicone straw until the straw seal is perfectly flat

against the collar. (Figure 3)

3. Snap the cap back onto the collar. (Figure 2)

4. Place the handle on the cup neck, pushing gently

until its notch fits into the cup jag. Screw the collar (with

the straw) onto the cup. (Figure 1)

Note: Do not close the cup when the orange sealing

ring is not in place or the cup will not function properly.

(Figure 5)

PREMIÈRE UTILISATION ET ASSEMBLAGE

Par mesure d’hygiène, mettre toutes les pièces

dans l’eau bouillante pendant 5 minutes avant la

première utilisation. Laver les pièces aussitôt après

usage. Démonter toutes les pièces comme indiqué

ci-après avant de verser l'eau bouillante ou d'utiliser

une autre méthode de stérilisation.

Désassemblage:

1. Dévisser le col et enlever les anses. (Fig. 1)

2. Enlever l’anneau d’étanchéité qui se trouve à

l’intérieur du col. (Fig. 2)

3. Détacher la paille du col en la tenant par l’extrémité

de la partie orange (près du joint d’étanchéité de la

paille) et en tirant fermement. (Fig. 3)

4. Détacher la partie transparente de la paille (rigide)

de la partie orange (en silicone). (Fig. 4)

Assemblage:

1. Insérer la partie transparente de la paille dans

l’extrémité la plus large de la partie orange en silicone.

(Fig. 4)

2. Insérer la partie orange de la paille dans le col en la

tenant par le bas. En la tenant par le haut, tirer

fermement sur la partie orange de la paille jusqu’à ce

que son joint d’étanchéité soit parfaitement appuyé

contre le col. (Fig. 3)

3. Remettre le capuchon en place sur le col en

exerçant une pression. (Fig. 2)

4. Placer les anses sur la base; appuyer délicatement

jusqu’à ce que les crans et les saillies s’emboîtent.

Visser le col (avec la paille) sur la base. (Fig. 1)

Remarque: Ne pas fermer le gobelet si l’anneau

d’étanchéité orange n’est pas installé. Le gobelet

risquerait alors de ne pas fonctionner correctement.

(Fig. 5)

PRIMER USO Y ENSAMBLAJE

Para garantizar la higiene del producto, coloque

todas las piezas en agua hirviendo por 5 minutos

antes del primer uso. Siempre lave todas las piezas

inmediatamente después de su uso. Asegurarse

de desamblar todos los componentes como se

indica debajo antes de poner en agua hirviendo u

otro componente de limpieza.

Para desarmar:

1. Desenrosque el cuello y quite la manija. (Fig. 1)

2. Retire con cuidado la tapa del cuello. (Fig. 2)

3. Retire la pajilla del cuello tirando firmemente en la

parte superior de la pajilla de silicona color naranja

(cerca del sello de la pajilla). (Fig. 3)

4. Retire la pajilla dura transparente de la pajilla de

silicona color naranja. (Fig. 4)

Para armarlo:

1. Empuje la pajilla dura transparente en el extremo

ancho de la pajilla de silicona color naranja. (Fig. 4)

2. Empuje la pajilla de silicona color naranja firmemente

en el cuello desde la parte inferior. Desde la parte

superior, tire firmemente en la pajilla de silicona color

naranja hasta que el sello de la pajilla esté

completamente plana contra el cuello. (Fig. 3)

3. Coloque la tapa en el cuello. (Fig. 2)

4. Coloque la manija en el cuello del vaso, empujando

suavemente hasta que la muesca encaja en la punta

del vaso. Enrosque el cuello (con la pajilla) en el vaso

(Fig. 1)

Nota: No cierre el vaso si el empaque no está

colocado; si lo hace, el vaso no funcionará

correctamente. (Fig. 5)

A: Cap

B: Collar

C: Straw

D: Handle

E: Cup

F: Straw Seal

G: Sealing Ring

Fig. 1

Fig. 3

Fig. 2 Fig. 5

Fig. 4

Remove Remove

Assemble

A: Cap

B: Collar

C: Paille

D: Anses

E: Base

F: Joint d’étanchéité

G: Anneau d’étanchéité

Fig. 1

Fig. 3

Fig. 2 Fig. 5

Fig. 4

Détacher Détacher

Assembler

A: Tapa

B: Cuello

C: Pajilla

D: Manija

E: Vaso

F: Sello de la pajilla

G: Empaque

Fig. 1

Fig. 3

Fig. 2 Fig. 5

Fig. 4

Retirar Retirar

Armar

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Joovy Pengdoo in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0.26 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Joovy Pengdoo Manual

Product: