767812

Joovy Cocoon X2 Manual

7
Zoom out
Zoom in
Previous page
1/28
Next page
EN FR ES
13 CAUTIONARY TOWING TIPS
• Stop trailer use immediately on poor road conditions, in severe weather or in any other dangerous environments.
• Ensure the trailer is completely disengaged from bicycle when not in use.
• Always store tow bar in a clean dry place.
• Before and after each use, inspect tow bar and discontinue use should it malfunction or become damaged.
• Not for use at high speeds. DO NOT exceed 10 MPH (16 km/h).
• Each child must wear an approved safety helmet when riding in the product in trailer mode.
• Always ensure your bicycle brakes function properly. Braking distance is increased when pulling a trailer.
• The trailer is wider than most bicycles. Allow extra clearance when near curbs, signs, parked cars and other obstacles.
• Do not turn sharply. A bicycle with a trailer requires a wide turning radius.
• Install a rearview mirror on your bicycle to check on children in the trailer.
Assembling and Using the Trailer Mode Attachment
To ensure safe operation of your trailer, please follow these instructions carefully.
!WARNING
Adult assembly is required for this product. No tools required for bicycles with a quick release axle on the rear wheel.
Bicycles without a quick release axle on the rear wheels will require an adjustable wrench.
!WARNING
Use caution not to get pinched by the locking clamp.
14 Removing the Coupler Attachment from the Tow Bar
• Locate the coupler attachment on the tow bar.
• To remove, carefully rotate the locking clamp off the tow bar. See Figure 14.1. Pull the locking pin out from the tube.
• Remove the coupler attachment from the tow bar tube. See Figure 14.2.
15 Installing/Uninstalling Coupler Attachment for Bicycles with Quick Release Rear Axles
• Flip the rear axle quick release lever open and remove the nut and spring from the opposite side. See Figure 15.1.
• Hold the lever and pull out the axle skewer with spring. See Figure 15.2.
• Completely remove the skewer while leaving the wheel in place.
• Placethecouplerovertheleftsideoftheaxlewiththeatsideofthecouplerattachmentfacinginwardagainsttheframeofthebicycle.
Insert the skewer through the wheel hub (and the coupler) and hook it onto the bicycle frame dropout. See Figure 15.3.
NOTE: The wide end of the spring should face outward and touch the quick release hub. See Figure 15.4.
• Replace the spring and then the nut onto the skewer. Turn the nut to tighten and then close the quick release lever. See Figure 15.5.
• Check the rear wheel to ensure it is tight and operating correctly.
• To remove this accessory, reverse the instructions in this section.
16 Installing/Uninstalling Coupler Attachment for Bicycles with Rear Hub Nuts
• Loosen the left rear wheel hub nut with a wrench.
• Remove the hub nut and washer from the axle. See Figure 16.1.
• Placethecouplerattachmentontotheaxlewiththeatsidefacinginwardagainsttheframeofthebicycle.See Figure 16.2.
• Replace the washer and the bicycle hub nut onto the axle and turn the nut to tighten. See Figure 16.3.
• Tighten the hub nut securely with a wrench.
• Check the rear wheel to ensure it is tight and operating correctly.
• To remove this accessory, reverse the instructions in this section.
17 Attaching/Detaching the Tow Bar to the Stroller/Trailer
• Tilt the stroller so it is resting on the handlebar and the rear wheels.
• Remove the front swivel wheels by pressing the release button located on the back of the front wheel housing and pulling the wheel away
from the stroller. Repeat for the other side.
• Remove the locking pin from the attachment housing (located on the lower front end of the stroller) by pulling the safety clamp over the pin
and sliding the pin out. See Figure 17.1.
• Insert the tow bar into the housing until the holes on the sides line up. See Figure 17.2.
• Insert the locking pin through the holes and attach the safety clamp over the pin to ensure it is secure. See Figure 17.3.
• Pull the tow bar away from the stroller to ensure it is securely installed.
• To remove this accessory, reverse the instructions in this section.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Joovy Cocoon X2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Joovy Cocoon X2 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info