780398
3
Zoom out
Zoom in
Previous page
1/12
Next page
EN FR ES
Place the Velcro® strap of the Caboose Rear Seat over the top peg on the respective side of the stroller and wrap the Velcro® strap
around the frame. See Figure 4.2.
Wrap the cloth strap over the Velcro strap so that the Velcro® attaches. Secure the peg through the button hole. See Figure 4.3.
Wrap the bottom strap around the frame and secure the bottom peg through the button hole. See Figure 4.4.
Repeat for the two straps on the other side.
Slide the front fabric pocket, located under the front of the Caboose Rear Seat, over the front of the bench seat. See Figure 4.5. (shows
the underside of the bench seat)
Locate the 2 long straps on the lower rear of the Caboose Rear Seat (one on each side). Wrap each strap around the outside of the
stroller handle bar and feed them through the loops on the back of the seat. Securely buckle the straps together. See Figure 4.6. If
necessary, pull the webbing near the male end of the buckle to tighten.
Near the front sides of the Caboose Rear Seat are 2 Velcro® straps (one on each side). Secure these straps around the lower horizontal
frame bar on both sides. See Figure 4.7.
Wrap the left and right armrests of the Caboose Rear Seat around the upper horizontal frame (on each side). Securely snap together both
snaps on each side. See Figure 4.8.
Check that the seat is securely in place.
5 Securing the Child in the Caboose Rear Seat
• Thereare3heightadjustmentpositionsfortheshoulderharness.Adjusttheheighttotheclosestheightaboveyourchild’sshoulders.
To remove the shoulder harness, turn the plastic ends sideways and push them through the slots in the seatback. Reattach the harness at
the proper height by reinserting the plastic ends through the slots. See Figure 5.1. Ensure both straps are the same height.
To unlatch the buckle press the center button and remove the male ends of each buckle. See Figure 5.2.
Carefully place the child in the seat with the shoulder straps over their shoulders and chest. Then place the crotch strap between the
child’slegs.
Push the shoulder/waist latch posts into the crotch buckle until all parts snap into place. See Figure 5.3.
• Tightenthewaistbelttobesnugaroundthechild’swaist.
The shoulder, waist, and crotch straps may be adjusted using the sliding plastic rings on these straps.
!WARNING
The Caboose Rear Seat is not suitable for children under 6 months. Avoid serious injury from falling or sliding out.
Always use the restraint system.
6 Seatback Positioning
The seat back can be adjusted to any position from fully upright to reclining. This seat should only be used for a child that is at least 6
months old.
To recline the seat, release the adjustment lock tab from its locked position by pulling it away from the seat back. Continue to pull this lock
tab downward to adjust the seat back to the desired position, then re-engage the lock tab. See Figure 6.1.
To adjust the seat back to a more upright position, release the adjustment lock tab from its locked position. Then simply pull up on the
adjustment strap ring until the seat back is in the desired position and re-engage the lock tab. See Figure 6.2.
!WARNING
Whether the seatback is upright or reclined, ALWAYS make certain that the recline mechanism is engaged before
placing the child into the seat.
7 Removing the Caboose Rear Seat
Unsnap the waist and shoulder straps from the crotch strap.
Unwrap the left and right armrests of the Caboose Rear Seat from around the upper horizontal frame (on each side). Unsnap both snaps
on each side. See Figure 7.1.
Near the front sides of the Caboose Rear Seat are 2 Velcro® straps (one on each side). Pull these straps apart. Repeat on the other side.
See Figure 7.2.
Locate the 2 long straps on the lower rear of the Caboose Rear Seat. Unbuckle the straps and unwrap each strap from around the outside
of the stroller handle bar by feeding them through the loops on the back of the seat. See Figure 7.3.
Locate the straps on the upper rear of the Caboose Rear Seat (two on each side). Unwrap them from the pegs. See Figure 7.4.
Push the rear seat crotch strap buckle through the slot in the Caboose Rear Seat (See Figure 7.5) and pull the Caboose Rear Seat off of
the rear bench.
8a Installing the Rear Bench Seat Waist Strap (Caboose Graphite & Caboose Ultralight Graphite
Only)
To install the rear bench waist strap, locate one end of the waist strap where it has a metal D-ring at the end.
Wrap the strap around the front seat rear tube. Slide the strap through the small opening of the metal D-ring and pull the strap to secure it
to the tube. Repeat for the other end of the strap. See Figure 8a.1.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Joovy Caboose Rear Seat 906X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Joovy Caboose Rear Seat 906X in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0.27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info