700456
10
Zoom out
Zoom in
Previous page
1/20
Next page
10 | JL Audio - XD600/1v2 Owners Manual
PREOUTS
The XD600/1v2 incorporates a buffered, pass-
through preamp output section, so that additional
amplifiers can be easily added to the system.
The preamp output delivers the same signal
that is connected to the XD600/1v2’s inputs.
Remote
Level
Control
+12 VDC Ground Remote
Mono Subwoofer Output
Note: The preamp output signal is not affected by
the amplifier’s filter controls. If the input signal is
full-range, the preamp output will be full-range.
Note: When the “Input Voltage” switch is in its
“Low position, the level of the “Preouts” signals
matches the input signal levels (unity gain). When
the “Input Level” switch is in the “high” position,
the level of the input signal is attenuated –12 dB
to produce a line level signal at the “Preouts”.
This ensures a proper line level signal output
under both conditions.
If you plan to use the “Preouts” to feed a stereo
amplifier, you must connect a stereo signal to
the input of the amplifier. A mono signal into
the amplifier will result in a mono signal out of
the preamp output.
SUBWOOFER OUTPUTS
The XD600/1v2 is designed to deliver power
into subwoofer loads equal to or greater than 2
ohms of nominal impedance.
The XD600/1v2’s subwoofer outputs are
designed to accept 16 AWG - 8 AWG wire. To
connect the subwoofer wires to the amplifier, first
back out the set screws on the top of the terminal
block, using the supplied 2.5 mm hex wrench.
Strip 1/2 inch (12 mm) of insulation from the
end of each wire and insert the bare wire into the
terminal block, seating it firmly so that no bare
wire is exposed. While holding the wire in place,
tighten the set screw firmly, taking care not to
strip the head of the screw.
Remote
Level
Control
+12 VDC Ground Remote
Mono Subwoofer Output
You will notice that there are two “+” positive
connections and two “–” negative connections.
This is to facilitate multiple subwoofer wiring.
The two positive and two negative
connections are connected in parallel inside
the amplifier. They are not stereo outputs.
Connecting two subwoofers, each to one set of
positive and negative terminals, will result in
a parallel subwoofer connection. When only
connecting one pair of subwoofer wires, it is not
necessary to use both sets of connections.
Subwoofer loads below 2 ohms nominal are not
recommended and may cause the amplifier
to initiate a protection mode, which reduces
power output.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JL Audio XD600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JL Audio XD600 in the language / languages: English as an attachment in your email.

The manual is 1,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info