700465
8
Zoom out
Zoom in
Previous page
1/20
Next page
8 | JL Audio - RD1000/1 Owners Manual
LOWPASS FILTER CONTROL
Most speakers are not designed to reproduce
the full range of frequencies audible by the human
ear. For this reason, most speaker systems are
comprised of multiple speakers, each dedicated
to reproducing a specific frequency range. Filters
are used to select which frequency range is sent
to each section of a speaker system. The division
of frequency ranges to different speakers can be
done with passive filters (coils and/or capacitors
between the amplifier outputs and the speakers),
which are acceptable and commonly used
for filtering between mid-range speakers and
tweeters. Filtering between subwoofer systems
and satellite speaker systems is best done with
active filters, which cut off frequency content at
the input to the amplifier. Active filters are more
stable than passive filters and do not introduce
extraneous resistance, which can degrade
subwoofer performance.
The active low-pass filter built into the
RD1000/1 is designed to attenuate frequencies
above its filter frequency, so that the system’s
subwoofers do not reproduce any audible
midrange content.
This serves to improve tonal balance and
to avoid distortion. Correct use of the filter
can substantially improve the fidelity of your
audio system.
+12 VDC Ground Remote
Turn On Mode
Rem.
|
Oset
|
Signal
Low
|
High
Clipping
Input Voltage
0
+12
+5
+10
+8
Bass Boost (dB) LP Filter Freq. (Hz)
Input Sensitivity
Monoblock Subwoofer Amplifier
MONO SUBWOOFER OUPUT
(
L
)
(
R
)
CH. 1
(
L
)
CH. 2
(
R
)
INPUT SECTION
PRE-OUTS
LP Filter Operation: The RD 500/1 monoblock
employs a 12 dB per octave low-pass active filter
with fully variable frequency selection between
50 Hz and 500 Hz via the “LP Filter Freq. (Hz)
control knob (80 Hz is a good starting point for
tuning most systems).
“BASS BOOST” CONTROL
The RD1000/1 monoblock includes a single
band, boost-only bass equalizer controlled
by a rotary knob marked “Bass Boost (dB)”.
This control has a boost range of 0 dB (full-
counterclockwise) to +12 dB (full-clockwise) and
is centered at 45 Hz.
+12 VDC Ground Remote
Turn On Mode
Rem.
|
Oset
|
Signal
Low
|
High
Clipping
Input Voltage
0
+12
+5
+10
+8
Bass Boost (dB) LP Filter Freq. (Hz)
Input Sensitivity
Monoblock Subwoofer Amplifier
MONO SUBWOOFER OUPUT
(
L
)
(
R
)
CH. 1
(
L
)
CH. 2
(
R
)
INPUT SECTION
PRE-OUTS
REMOTE LEVEL CONTROL OPTIONAL
With the addition of the optional Remote
Level Control (RBC-1), you can control the
subwoofer volume from the front of the vehicle.
Remote
Level
Control
(RBC-1)
Mono Subwoofer Output
INPUT SECTION
(
L
)
(
R
)
(
L
)
(
R
)
PREOUTS
+12 VDC Ground Remote
The RBC-1 connects to the jack labeled
Remote Level Control (RBC-1)” on the
Connection Panel of the amplifier using a
standard telephone cable (supplied with the
RBC-1). If desired, multiple RD amplifiers can be
controlled from a single RBC-1 controller using
a single-line, four-wire phone line splitter and
multiple phone cables.
When connected to the amplifier, the RBC-1
operates as follows: At full counter-clockwise
rotation, the audio will mute completely. At full
clockwise rotation the level will be the same as
if the RBC-1 was not connected at all. In other
words, it operates strictly as a level attenuator.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JL Audio RD1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JL Audio RD1000 in the language / languages: English as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info