700489
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
The Nine-Step Procedure
1) Disconnect the Speaker Connector Plug.
2) Turn off all processing on the source unit
(bass/treble, loudness, EQ, etc.). Set fader
control to center position and subwoofer
level control to 3/4 of maximum (if used
to drive the MHD750/1). Disconnect
the HD-RLC Remote Level Control
temporarily (if one is being used).
3) Switch the “Input Voltage” to “Low” and turn
the “Input Sens.” control all the way down.
4) Set the source unit volume to 3/4 of full
volume. If the amplifier is being driven by a
source unit’s dedicated subwoofer output, also
adjust the source units subwoofer level control
to 3/4 of maximum output. This will allow for
reasonable gain overlap with moderate clipping
at full volume.
5) Using the chart below, determine the
target voltage for input sensitivity
adjustment according to the nominal
impedance of the speaker system
connected to each set of outputs.
Nom.
Impedance
MHD 750/1
MONO
8 54.8 V
6 54.8 V
4 54.8 V
3 47.4 V
2 38.7 V
1.5 33.5 V
6) Verify that you have disconnected the Speaker
Connector Plug before proceeding. Play a
track with an appropriate sine wave (within
the frequency range to be amplified by each
set of channels) at 3/4 source unit volume.
7) Connect the AC voltmeter to the Speaker
Output contacts of the amplifier.
8) Increase the “Input Sens.” control until the
target voltage is delivered. If excessive voltage
is read with the control at minimum (full
counterclockwise), switch the “Input Voltage
switch to “High” and re-adjust.
9) Once you have adjusted the amplifier to its
maximum unclipped output level, reconnect
the speaker(s). The “Input Sens.” controls can
now be adjusted downward if the MHD750/1
requires attenuation to achieve the desired
system balance.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JL Audio MHD750 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JL Audio MHD750 in the language / languages: English as an attachment in your email.

The manual is 1,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info