701252
7
Zoom out
Zoom in
Previous page
1/12
Next page
7
FLUSHMOUNT INSTALLATION
1) Detach the preinstalled surface-mount
fixture by inserting a small flat screwdriver
into the slots behind the tweeter flange
and carefully pry open to release.
2) Remove the vehicle panel and check the desired
mounting location to ensure that there is adequate
clearance behind the panel for the tweeter’s
magnet structure and mounting hardware.
3) Carefully cut a 1-7/16-inch (37 mm) diameter hole
in the vehicle panel. This will achieve a snug fit and
allow the tweeter flange to conceal the cut line.
4) Select a suitable length stud bolt for your panel’s
thickness and screw its short end into the rear of the
tweeter using the fixed M4 nut to tighten.
5) Insert the tweeter from the front of the panel (do
not attach the spring clip at this time).
6) Attach the spring clip from behind the panel using
the supplied M5 nut and tighten by hand until the
tweeter is tight on the panel. Do not overtighten.
8) Connect the tweeter’s wires to the wire leads from
the crossover, observing correct polarity.
9) Re-install the vehicle panel, taking care to
route the new wiring so as not to interfere
with any vehicle mechanisms (window
mechanisms, for example).
< OR >
Stud bolts are provided in two lengths to accommodate different panel thicknesses.
10 mm length 25 mm length
DIAGRAM E:
Flush-Mount Tweeter Installation
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JL Audio C1-650 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JL Audio C1-650 in the language / languages: English as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info