701262
6
Zoom out
Zoom in
Previous page
1/16
Next page
13W7AE Subwoofer: Amplifier Recommendation.
HD1200/1 (shown) or 1200/1v3
RECOMMENDED CONTINUOUS RMS POWER RANGE FOR ONE SUBWOOFER DRIVER:
750W 1000W 1500W 2000W
4000W
500W
13W7AE
= position of knob
= position of switch
= switch with two possible positions
= setting will vary (see sidebar)
13W7AE-D1.5
Free Air Resonance (Fs): 23.5 Hz
Electrical “Q” (Qes): 0.476
Mechanical “Q” (Qms): 7.517
Total Speaker “Q” (Qts): 0.448
Equivalent Compliance (Vas): 3.68 cu. ft. (104.3 ltrs)
One-Way, Linear Excursion (Xmax)*: 1.25 in. (32 mm)
Thermal Power Handling (Pt):
1500 Watts Continuous
Reference Efficiency (no): 0.269 %
Efficiency (SPL @ 1W/1m): 86.3 dB
DC Resistance (Re): 2.41Ω
Effective Piston Area (Sd): 107.35 sq. in. (0.0693 sq. m)
Nominal Impedance (Znom): Dual 1.5Ω
* Xmax specifications are derived via one-way voice coil
overhang method with no correction factors applied.
** For parallel-wired voice coils, divide “Re” by 4.
All other specifications remain the same.
Remote Level Control
Requires HD-RLC controller (sold separately).
Multiple ampliers can be controlled with
one controller by adding standard phone
cable splitter (not included). This is a true
subwoofer level control, not a “bass boost”.
Output Polarity:
Carefully listen to the sub-bass to mid-bass transition with music
that has strong mid-bass content. Select the switch position
which gives the smoothest, most natural mid-bass response. If
using multiple HD1200/1’s on multiple subwoofers, make sure
this switch is set to the same position on all amplifiers.
Infrasonic Filter:
TurnO” for Sealed Enclosure.
Select “30Hz” for Ported Enclosure.
Input Sensitivity Controls:
Proper adjustment of
these controls is critical!
For virtually all aftermarket
head units, set “Input
Voltage” to “Low. See
Input Sensitivity Setting
Guide on pg. 14 for precise
setting instructions.
Filter Mode & Slope:
Set “Mode” switch to
LP. Set “Slope” switch to
24dB. Set “Filter Freq.
(Hz)” knob to “85”.
Lower settings are likely to
result in a poor transition
between the upper
response of the W7AE and
the lower response of the
mid-bass speakers.
JLAudio HD1200/1:
These settings are intended as a
“baseline” for tuning your system.
Depending on your vehicle and
your preferences, some variation
in the crossover and bass control
settings may be necessary for
optimum performance.
6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JL Audio 8W7AE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JL Audio 8W7AE in the language / languages: English as an attachment in your email.

The manual is 2,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info