810177
11
Zoom out
Zoom in
Previous page
1/12
Next page
10
RALLYBAR RALLYBAR S RALLYBAR XL
Soundbar Housing Dimension
(L x W x H)
21-5/32" x 5" x 4-5/8"
(537.5 x 126.7 x 118mm)
21-5/32" x 5" x 4-5/8"
(537.5 x 126.7 x 118mm)
35-11/32" x 5" x 4-5/8"
(897.5 x 126.7 x 118mm)
Soundbar Dimension
(L x W x H)
21-5/32" x 5-5/16" x 4-5/8"
(537.5 x 135.2 x 118mm)
21-5/32" x 5-5/16" x 4-5/8"
(537.5 x 135.2 x 118mm)
35-11/32" x 5-5/16" x 4-5/8"
(897.5 x 135.2 x 118mm)
Soundbar Weight 11.57 lbs (5.25 kg) 11.46 lbs (5.2 kg) 20.83 lbs (9.45 kg)
Packaging dimensions
(W x H x D)
24" x 9" x 7.6"
(611 x 229 x 193mm)
24" x 9" x 7.6"
(611 x 229 x 193mm)
38.2" x 9" x 7.6"
(971 x 229 x 193mm)
Gross weight 17.14 lbs (7.79 kg) 17 lbs (7.74 kg) 27.5 lbs (12.52 kg)
Maximum Operation
Temperature: 45 °C 45 °C 45 °C
9. TROUBLESHOOTINGS
Caution:
Never try to repair the product by yourself. If you have any problems while using this product, check the following points before you request
service.
Problem Causes and Solutions
No sound (Standby indicator is off) Check that the soundbar’s +12V and GND connections have been properly made.
Check if the fuse on the +12V wire located near the battery is blown; if so, replace it with an
identical fuse.
No sound from the speaker Ensure that the soundbar is powered on and operation mode is on
Adjust volume.
Ensure that a sound source is active and not muted.
Bluetooth device cannot connect
with the soundbar
Ensure that the Bluetooth function of the device is enabled.
The soundbar is already connected with another Bluetooth device. Hold button on the soundbar
for more than 5 seconds to disconnect and pair with a new device.
Poor audio quality from a connected
Bluetooth device.
The Bluetooth reception is poor. Move the device closer to the soundbar, or remove any obstacle
between the device and the soundbar.
No response from some buttons The product may be in demo mode. In demo mode, all the USB&Bluetooth input sources and buttons
except are disabled. Hold and simultaneously for more than 5 seconds to exit.
USB DISK FIRMWARE Upgrade
failed and soundbar get brick or
Soundbar hang up after unplugging
U-disk during upgrading process
In this case, please re-do the firmware upgrade process again to make the soundbar work: make
main power switch off. Press and hold the “volume up” & “BT” button at same time then turning on
the main power switch, after 1 second, release hand from the “volume up” & “BT” buttons to trigger
the firmware upgrade.
Cannot auto resume USB music
after deep stand by or main power
on/off
Press play/pause button to resume soundtrack play from USB disk
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL RallyBar at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL RallyBar in the language / languages: English as an attachment in your email.

The manual is 7.48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info