Manual JBL k2 s4800 kersen (page 33 of 42) (English)

422468

Zoom out

Zoom in

1/42

Project Everest DD66000

CHAPTER 8

Project Everest DD66000 Connections

Caution: Turn all amplifiers off before connecting or disconnecting Project

Everest DD66000 loudspeakers. Making connections while an amplifier is

operating could seriously damage the loudspeaker system and void the

warranty. All amplifiers must also be turned off before connecting or

disconnecting cables at the amplifier or preamplifier inputs.

All connections between the amplifier(s) and the Project Everest DD66000

loudspeaker system are made at the terminals located on the back of the

enclosure. The left-hand terminals (black letters) are negative, and the right-

hand terminals (red letters) are positive. These correspond to the negative and

positive conductors in the speaker wire.

Assign one of the two conductors as the negative conductor and the other as the

positive conductor. Use these same designations for all system wiring. Always

connect the conductors of the speaker wire appropriately to the corresponding

negative and positive terminals on all system components. This will ensure that

all components will work together (“in phase”). Connecting the speakers out of

phase will not damage them but will result in reduced low-frequency output

and impaired stereo effect.

Speaker wires may be fastened to the terminals by several

methods. The most positive connection is often made by directly

connecting clean, bare connectors (exposed by stripping the ends

of the wire) to the terminal posts.

For this type of connection, loosen the knobs on the terminals

and insert the exposed (bare) end of each speaker wire into the

hole exposed on the terminal shaft (+ to +, – to –). Retighten the

knob on each terminal so that a snug positive connection is

achieved. Do not apply excessive force and do not overtighten.

To avoid a short circuit, trim off any excess wire that is not in

contact with the binding post contact surfaces.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of JBL k2 s4800 kersen in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

JBL k2 s4800 kersen Manual

Product: