422468
30
Zoom out
Zoom in
Previous page
1/42
Next page
30
Battery Installation
The network of this system utilizes the proprietary JBL “charge-couple
method” to activate capacitors by applying DC bias using battery power; this
eliminates unwanted distortions. Please refer to procedures below and install
the supplied batteries in the battery holders.
Battery Installation Procedures:
1.
Remove the control panel cover at the
bottom of the front baffle (refer to figures
in Chapter 7).
2.
Remove the packaging film from batteries
and place these batteries into the battery
holders inside the control panel, on the left.
The connector is the snap type and has
polarities. Push each battery up after making
sure that the polarity orientation is correct.
3.
Put the control panel cover back on the baffle.
Bias is applied to capacitors, which are insulation components; therefore, there
is no current consumption in batteries. Thus, the battery life is the same as that
for batteries with natural discharge (about two years in alkaline batteries).
Only 006P rectangular 9V alkaline batteries may be used. This battery can be
easily found at electronic/appliance stores and convenience stores.
Please Note:
The supplied batteries are for testing the bias function; they should be
replaced with new batteries as soon as possible.
Bias is applied to reduce distortion from the components. In the event
of a flat battery, there is no effect on the network circuitry, and there
is no symptom (e.g., no sound or intermittent sound from the system).
However, you will notice an effect on the level of distortion reduction
in the bias network circuitry after new batteries are installed.
The batteries provide a voltage bias to each of the capacitor positions in the
various networks. The biasing of the capacitors is done through a large value
resistor (2.2 MO) and thus draws no appreciable current. The expiration date
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL k2 s4800 kersen at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL k2 s4800 kersen in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info