CAUSE and SOLUTION: No voltage at BATT+ and/or REM terminals, or bad or no ground connection. Check voltages at amplifier terminals with VOM.
PROBLEM: No audio and PROTECT INDICATOR flashes every 4 seconds.
CAUSE and SOLUTION: DC voltage on amplifier output. Amplifier may need service.
PROBLEM: No audio and PROTECT INDICATOR is on.
CAUSE and SOLUTION: Amplifier is overheated. Make sure amplifier cooling is not blocked at mounting location. Verify that speaker-system impedance is within
specified limits. Or, there may be voltage greater than 16V (or less than 8.5V) on BATT+ connection. Check vehicle charging system.
PROBLEM: No audio and PROTECT and POWER INDICATORS flash.
CAUSE and SOLUTION: Voltage less than 9V on BATT+ connection. Check vehicle charging system.
PROBLEM: Distorted audio.
CAUSE and SOLUTION: Gain is not set properly. Check INPUT LEVEL setting. Check speaker wires for shorts or grounds. Amplifier or source unit may be defective.
PROBLEM: Distorted audio and PROTECT INDICATOR flashes.
CAUSE and SOLUTION: Short circuit in speaker or wire. Remove speaker leads one at a time to locate shorted speaker or wire, and repair.
PROBLEM: Music lacks dynamics or “punch.”
CAUSE and SOLUTION: Speakers are not connected properly. Check speaker connections for proper polarity.
PROBLEM: Amplifier fuse keeps blowing.
CAUSE and PROBLEM: The wiring is connected incorrectly or there is a short circuit. Review installation precautions and procedures in manual. Check wiring
connections.
PROBLEM: Engine noise—whining or clicking—in system when the engine is on.
CAUSE and PROBLEM: Amplifier is picking up alternator noise. Turn down gain. Move audio cables away from power wires. Install an alternator noise filter on power
line between battery and alternator. Check ground connections on the amplifier since a loose or improper ground is one of the main causes for extraneous noise
in your audio system.
CHAPTER 6: SPECIFICATIONS
ModelRMS power @ 4 ohmsRMS power @ 2 ohms
RMS power @ 4 ohms
Bridged
Total peak
power
Frequency response
Maximum
signal input
Maximum
sensitivity
Line in signal-to-noise ratio
(reference to 1 watt @ 4 ohm)
GTR-102100W x 2, ≤0.1% THD+N120W x 2,≤0.1% THD+N240W x 1, <0.3% THD+N700W15Hz-35kHz10V200mV≥75dBA
GTR-104100W x 4, ≤0.1% THD+N120W x 4, ≤0.1% THD+N240W x 2, <0.3% THD+N1500W15Hz-35kHz10V200mV≥75dBA
GTR-7535
75W x 4, ≤0.1% THD+N100W x 4, ≤0.1% THD+N200W x 2, <0.3% THD+N
2300W
15Hz-35kHz
(full range),
10V200mV
≥75dBA (full)
200W x 1, ≤0.1% THD+N350W x 1, ≤0.1% THD+N–15Hz-320Hz (sub)≥80dBA (sub)
GTR-601380W x 1, ≤0.1% THD+N600W x 1, ≤0.1% THD+N–1500W15Hz-320Hz20V200mV≥80dBA
GTR-1001700W x 1, ≤0.1% THD+N1000W x 1, ≤0.1% THD+N–2600W15Hz-320Hz20V200mV≥80dBA
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for JBL GTR-100 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of JBL GTR-100 in the language / languages: English as an attachment in your email.
The manual is 1,42 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
