422793
27
Zoom out
Zoom in
Previous page
1/42
Next page
Project Everest DD66000
27
CHAPTER 7
Project Everest DD66000 Switch Operations
The DD66000 has two control panels under the
cover at the center bottom of the front baffle.
Shorting bars or switches inside the control panel
allow you to switch orientation of the system, engage
bi-amplification if desired and adjust woofer and
high-frequency levels. They also provide access to
the 9-volt batteries used for capacitor bias. Remove
the control panel cover, referring to the illustrations
on the right, and make necessary adjustments.
To change setups using shorting bars, use the supplied hexagonal driver to
remove the screws securing the bar. Move the bar according to the setup you
prefer and then put the screws back.
Attention: As loose mounting screws on the terminals could cause bad contact,
make sure that they are firmly attached. However, if you overtighten, there is a
risk of damaging the terminals themselves. Please use the supplied hexagonal
driver and tighten screws with reasonable torque, by hand only. Do not use
powered screwdrivers of any type.
The following adjustments are made by using the above procedure.
System Orientation
The two low-frequency drivers operate over different ranges, as described
earlier. For proper imaging, it is necessary that the midrange woofer (LF2) be
in the inboard position for the pair of systems. The proper setting of the system
orientation jumper bars can configure a single DD66000 system as either a “leftor
“right” system. It is necessary that both bars be moved together. Improper
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL everest dd66000 maple at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL everest dd66000 maple in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info