809546
6
Zoom out
Zoom in
Previous page
1/12
Next page
6
The CS480 satellites and center channel are designed to be mounted
onthe wall. There is a fixed-mount wall bracket and an adjustable
wall bracket provided for each satellite and the center channel. Each
speaker bracket will require up to four 1-1/2"#10
wood screws; each
screw should be fastened to a wall stud. If a wall stud is unavailable,
install an anchor appropriate for a 1-1/2"
#10 screw.
NOTE: The customer is responsible for the correct selection
and use of mounting hardware (available through hardware stores)
that will ensure the proper and safe wall-mounting of the speakers.
Fixed-Mount Wall Bracket
Step 1. Mark the positions on the wall where you would like to
place the mounting screws.
Step 2. Attach the bracket to the wall using two screws
(not included).
Step 3. Remove the rubber ring on the bottom of the satellite and
seat the satellite or center channel speaker onto the back bracket.
Step 4. Attach the 1/4-20 screw into the insert on the bottom of the
speaker and tighten.
Adjustable Wall Bracket
Step 1. Remove the cap over the threaded insert on the rear of the
speaker.
Step 2. Mark the positions on the wall where you would like to place
the mounting screws.
Step 3. Place the bracket against the wall and fasten four 1-1/2" #10
wood screws (not included) through the bracket’s screw holes into
the wall. If a wall stud is not available, use an appropriate anchor.
Step 4. Unscrew the round collar (C) from the bracket (A).
Step 5. Screw the ball and shaft assembly (B) to the 1/4"-20 insert on the
back of the satellite or the center channel (do not use the bottom insert
on either speaker). Back out 1/2 of a turn and tighten the nut against the
speaker.If the ball and shaft assembly is not backed out before tighten-
ing the nut, performing Step 8 below may dislodge the threaded insert in
the speaker housing and permanently damage the speaker.
Step 6. Attach the speaker wire as shown on page 7.
Step 7. Drop the round collar (C) over the ball and shaft assembly
(B) that is mounted to the speaker with the finished side of the collar
facing the rear of the speaker.
Step 8. Carefully push the ball straight into the socket mounted on the
wall, angle the speaker as desired and tighten the collar using the
enclosed metal bar.
Figure 3. Bracket on wall.
Metal bar
Metal bar
®
®
®
A
BC
WALL -MOUNTING THE SATELLITES
AND CENTER CHANNEL
CS 480-120V om.qxd 12/15/06 4:43 PM Page 8
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL CS480 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL CS480 in the language / languages: English as an attachment in your email.

The manual is 1.28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info