650516

JBL CristalProfi e701 Manual

30
Zoom out
Zoom in
Previous page
1/201
Next page
26
Place the ceramic shaft and impeller back in the casing. Check that both rubber bearings are
present and correctly positioned for the ceramic shaft. Put the impeller cover back in and,
pressing gently, turn the cover towards “CLOSE” until the stop point.
Please note: If the impeller has to be replaced due to wear and tear, the complete set com-
prising the impeller with the shaft and 2 rubber bearings must be replaced. Only this way
can flawless operation and quiet running be guaranteed. When the impeller and shaft are
removed, a rubber bearing often adheres to the base of the impeller casing where it is very
difficult to remove. JBL has produced a special tool for this purpose which is available at
specialist pet shops under the name “Extraction tool for impeller bearing”. A useful cleaning
brush for the impeller casing comes with the tool.
11
Re-starting the filter
Place the hose connection block with the attached hoses back in position as described in
(2). Then turn the right-hand stopcock lever towards “OPEN” until the stop point. Repeat
with the left-hand lever a few seconds later.
If the water does not begin to run into the filter automatically, start the filter as described in (5).
Connect the filter to the mains power supply.
What to do if…?
The pump head cannot be correctly fitted
Cause Solution
One or more lter baskets too full or not
positioned correctly on top of one another
Do not overll lter baskets, check the baskets are
properly stacked on top of each other
Filter on pump head leaks
Cause Solution
Fastening clips not closed or not properly closed Close all fastening clips correctly
Prole seal washer dirty Clean sealing surfaces and grease with Vaseline
Prole seal washer tted incorrectly, twisted,
damaged or missing.
Position seal washer correctly or replace
Filter does not run or no water flows out
Cause Solution
No power supplied Plug into power supply
No water in the lter
Filter does not have automatic suction! Press start
button and ll lter with water (5)
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL CristalProfi e701 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL CristalProfi e701 in the language / languages: All languages as an attachment in your email.

The manual is 6,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info