507345
6
Zoom out
Zoom in
Previous page
1/30
Next page
6
WALL CORNER-MOUNTING
CAUTION
The customer is responsible for proper selection and use of mounting hardware
(available through hardware stores), to properly and safely wall-mount the
speakers. The JBL Control NOW speaker was designed to be easily installed.
However, if you are unable to clearly and fully understand and follow the
instructions in this manual, or if you are unsure of your ability to properly install
these loudspeakers, please contact your dealer or a qualifi ed installer. Please
do not use any power tools during installation. Power tools can exert excessive
and unnecessary torque which, in turn, can damage fasteners or other parts
and accessories, reducing their strength and causing possible failure of the
fastener or part. A failed or damaged fastener or part may not be able to
perform as designed, and may lead to an unsafe installation.
When deciding upon a location for the JBL Control NOW speaker, take care
NOT to install the mounting bracket closer than 3" (7,6 cm) (horizontal) and 8-1/2"
(21,5 cm) (vertical) to the ceiling. Any closer than the minimum measurements
will not allow the room needed to position and slide the JBL Control NOW
speaker into the mounting bracket.
1. Run the wiring to the location desired
for mounting the JBL Control NOW
speaker.
2. Attach the mounting bracket to the wall. Be sure to use appropriate anchors.
8-1/2" (21,5 cm) Minimum
distance from ceiling
3" (7,6 cm) Minimum
(horizontal mount)
distance
from ceiling
(vertical mount)
Appropriate
anchors
3. Connect the wires to the JBL Control NOW speaker.
IMPORTANT: Make sure all equipment is turned off before making
any connections. For speaker connections, use a high-quality speaker wire
with polarity coding. The side of the wire with a ridge or other coding is
usually considered positive polarity (i.e., +).
NOTE: If desired, consult your local JBL dealer about speaker wire and
connection options.
RED = +
BLACK = —
1. Strip 1/4" (6 mm) of wire
2. Press and push connector
3. Insert bare end;
release push connector
The speakers have coded terminals that
accept a variety of wire connectors. The most
common connection is shown in the diagram
to the left. To ensure proper polarity, connect
each + terminal on the back of the amplifi er
or receiver to the respective + (red) terminal
on each speaker, as shown. Connect the
– (black) terminals in a similar way. See
the owner’s guides that were included with
your amplifi er, receiver and television to
confi rm connection procedures.
IMPORTANT: Do not reverse polarities (i.e., + to – or – to +) when making
connections. Doing so will cause poor imaging and diminished bass response.
RED = +
BLACK = —
Standard
Connection
Wiring diagram shows
polarity connections for
one channel of a stereo or
home theater system.
Corner/Wall-Mount-
Bracket Assembly
NOTE: There are two
cable access holes
provided in the Wall-
Mount Assembly.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL Control NOW AW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL Control NOW AW in the language / languages: English as an attachment in your email.

The manual is 4,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JBL Control NOW AW

JBL Control NOW AW User Manual - German - 30 pages

JBL Control NOW AW User Manual - Dutch - 30 pages

JBL Control NOW AW User Manual - Danish - 30 pages

JBL Control NOW AW User Manual - French - 30 pages

JBL Control NOW AW User Manual - Italian - 30 pages

JBL Control NOW AW User Manual - Spanish - 30 pages

JBL Control NOW AW User Manual - Finnish - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info