809532

JBL CINEMA SOUND CS 600 SAT Manual

5
Zoom out
Zoom in
Previous page
1/8
Next page
5
CONNECTIONS
After placing the speakers, you are ready to connect your system.
First, turn off all audio-system power. Use high-quality speaker wire
tomake your connections; #18-gauge speaker wire with polarity cod-
ing is recommended. For longer distances, #16-gauge or heavier wire
isrecommended. The side of the wire with a ridge or other coding is
usually considered positive polarity (i.e., +). Also, consult the owner’s
manuals that were included with your amplifier or receiver to confirm
connection procedures. Observe polarities when making speaker
connections, as shown in Figure 4. Connect each + terminal on the
back of the amplifier or receiver to the respective + (red) terminal
on each speaker. Connect the – (black) terminals in the same way.
Important!
Do not reverse polarities (i.e., + to –, or – to +) when making
connections. Doing so will cause poor imaging and diminished
bass response. Be certain that positive and negative wire strands
are completely isolated to avoid short circuits that may damage your
equipment.
NOTE: On certain models using hexagonal terminal nuts, a small
socket wrench is provided to help in properly tightening the terminals.
Hand-tighten only and do not overtighten.
Figure 4. Wiring diagram shows polarity connections
for one channel of a home theater system.
MAINTENANCE AND SERVICE
The enclosure may be cleaned using a soft cloth to remove finger-
prints or to wipe off dust.
All wiring connections should be inspected and cleaned or remade
periodically. The frequency of maintenance depends on the metals
involved in the connections, atmospheric conditions and other
factors, but once per year is the minimum.
If a problem occurs, make sure that all connections are properly
made and clean. If a problem exists in one loudspeaker, reverse the
connection wires to the left and right system. If the problem remains
in the same speaker, then the fault is with the loudspeaker. If the
problem appears in the opposite speaker, the cause is in another
component or cable. In the event that your speaker ever needs
service, contact your local JBL dealer or distributor, or visit
www.jbl.com for a service center near you.
Receiver or Amplifier
(rear view)
Output
One Channel Shown
Black = –
Red =+
Red =+
Loosen
Terminal
Insert Bare
End; Tighten
Terminal
Black =–
No Stripe = –
Stripe = +
Speaker Wire
CS600 OM.qxd 11/28/06 2:32 PM Page 7
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL CINEMA SOUND CS 600 SAT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL CINEMA SOUND CS 600 SAT in the language / languages: English as an attachment in your email.

The manual is 0.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info