769386

JBL 104 Reference Monitors Manual

10
Zoom out
Zoom in
Previous page
1/16
Next page
10
The JBL 104 Reference Monitors are equipped with a low-power "Standby Mode” that automatically reduces
the power consumption when signal is not detected for a period of 19 minutes. Once in Standby Mode, normal
operation is restored when signal is detected. It is normal to experience a momentary delay prior to resumption
of audio. Standby Mode is enabled by default, but it can be disabled for professional applications that require
the speakers to be fully operational at all times. Standby Mode can be disabled/enabled using the procedures
listed below.
DISABLING AND ENABLING STANDBY MODE
To disable Standby Mode, use the following procedure:
1. Set POWER switch to the OFF position.
2. Connect headphones to the HEADPHONE output on the MASTER MONITOR.
3. Set the VOLUME control to the minimum (full counter-clockwise) setting.
4. Set the POWER switch to the ON position. Within a period of 15 seconds complete the following steps:
a. Disconnect the headphones.
b. Reconnect the headphones.
c. Disconnect headphones again.
d. Reconnect headphones again.
NOTE: This procedure must be completed within 15 seconds after performing Step 4. The POWER LED
will ash rapidly 5 times to indicate the process is complete.
To re-enable Standby Mode, use the following procedure:
1. Set POWER switch to the OFF position.
2. Disconnect headphones from the HEADPHONE output on the MASTER MONITOR.
3. Set the VOLUME control to the minimum (full counter-clockwise) setting.
4. Set the POWER switch to the ON position. Within a period of 15 seconds complete the following steps:
a. Connect the headphones.
b. Disconnect headphones.
c. Connect headphones again.
d. Disconnect headphones again.
NOTE: This procedure must be completed within 15 seconds after performing Step 4. The POWER LED
will ash slowly 2 times to indicate the process is complete.
5. Increase the setting of the VOLUME control (rotate clockwise).
6. Standby Mode will now be active, and after 19 minutes with no signal present, the 104 Reference
Monitors will enter Standby Mode.
Section 5: Standby Mode
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL 104 Reference Monitors at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL 104 Reference Monitors in the language / languages: English as an attachment in your email.

The manual is 1.92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info