Manual Janome MS5027 Pink ribbon (page 35 of 111) (English)

602083

Zoom out

Zoom in

1/111

1 2

Threading the Machine

• Threading the machine

* Raise the thread take-up lever to its highest position by

turning the handwheel counterclockwise.

* Raise the presser foot lifter.

* Place a spool on the spool pin, with the thread coming

off as shown.

Draw the end of the thread around the upper thread guide.

While holding the thread near the spool, draw the end of

the thread down around the check spring holder.

Firmly draw the thread up from right to left over the

take-up lever, and down into the take-up lever eye.

Slide the thread behind the needle bar thread guide on

the left.

Thread the needle from front to back, or use a needle

threader.

• Needle threader

q Knob

w Hook

e Guide

r Thread end

z Raise the needle to its highest position. Push down the

needle threader knob q as far as it will go.

The hook comes out through the needle eye from

behind.

x Paying close attention to the needle point, draw the

thread around the guide e and under the hook w.

c Release the knob slowly while holding the thread end r

with your hand. A loop of the thread is pulled up through

the needle eye.

NOTE:

The needle threader can be used with a #11 to #16

needle, or a #11 Blue needle.

Thread size 50 to 100 is recommended.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Janome MS5027 Pink ribbon in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Janome MS5027 Pink ribbon Manual

Product: