602083

Janome MS5027 Pink ribbon Manual

19
Zoom out
Zoom in
Previous page
1/111
Next page
12
Flat side
Lado plano
Méplat vers
Needle
Aguja
Aiguille
1
3
2
1
2
1
3
2
1
2
3
1
1
2
1
2
2
2
1
1
3
2
Changing Needle
Needle clamp screw
Needle clamp
Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw by
turning it counterclockwise. Remove the needle from the
needle clamp .
Insert a new needle into the needle clamp with the
flat side to the rear. When inserting the needle into the
needle clamp , push it up as far as it goes. Tighten
the needle clamp screw firmly by turning it clockwise.
To see if the needle is good, place the flat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
1
3
2
1
3
2
1
1
To Remove and Attach the Foot Holder
Thumb screw
Foot holder
Presser bar
•To remove
Remove the thumb screw by turning it counterclockwise
with a screwdriver.
•To attach
Match the hole in the foot holder with the threaded
hole in the presser bar . Fit the thumb screw into
the hole. Tighten the screw by turning it clockwise with
a screwdriver.
1
3
2
1
Changing Presser Foot
Snap-on button (red button)
Groove
Pin
•To remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button on the back of the foot holder.
•To attach
Place the selected presser foot, so that the pin on the
foot lies just under the groove on the foot holder. Lower
the presser bar to lock the foot into place.
3
2
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome MS5027 Pink ribbon at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome MS5027 Pink ribbon in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info