602010
14
Zoom out
Zoom in
Previous page
1/109
Next page
13
Threading for bobbin winding
1 Hold the upper thread with both hands and place it
down into the Slit.
2 Guide the thread around the Thread Guide following
the dashed line as shown in the diagram.
3 Thread through the hole in the Bobbin from the
inside to the outside. Put the Bobbin on the Bobbin
Winder Spindle.
4Push it to the right.
5 Hold the free end of the thread in your hand and
depress the foot control.
Stop the machine after the bobbin has made
several turns, and cut the thread close to the hole
in the bobbin.
6 Depress the Foot Control again. When the Bobbin
is fully wound, it will stop automatically.
Release the Foot Control and return the Bobbin
Winder Spindle to its original position by moving it
to the left, and cut the thread with the Bobbin
Thread Cutter as shown.
1 Bobbin Winder Stopper
2 Bobbin Thread Cutter
NOTES:
The machine will not sew until the spindle has been
returned to the left.
You can use either the Foot Control or the Start/Stop
Button to wind the Bobbin.
For safety purposes, the machine will stop
automatically 1.5 minutes after starting bobbin
winding.
5
4
6
1
2
1
2
3
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Memory Craft 9500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Memory Craft 9500 in the language / languages: English as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info