472823

Janome Memory Craft 6300 Manual

66
Zoom out
Zoom in
Previous page
1/69
Next page
63
The machine is started when it halts due to the
overload.
The feed dog is lowered while sewing.
The bobbin winder spindle is locked while winding a
bobbin.
Wait for at least 15 seconds to
start.
Do not lower or raise the feed dog
while the machine is running.
Turn off the power and remove
tangled threads.
The machine is out of order due to a problem in the
control circuit.
Contact the service center or the
store from whom the machine
was purchased.
The foot control is disconnected while sewing.
The power is turned on while depressing the foot control.
Connect the foot control and start
the machine.
Release the foot control.
The machine is started without lowering the presser
foot.
The thread cutter button is pressed with the presser
foot raised.
The machine will stop if the presser foot is raised
while sewing locking stitches.
Lower the presser foot and start
the machine.
Lower the presser foot and press
the thread cutter button again.
Raise the presser foot after locking
stitches are completely finished.
The machine will stop if the buttonhole is sewn
without lowering the buttonhole lever.
Lower the buttonhole lever and
start the machine.
Problems and Warning Signals
If a buzzer sounds and the LCD screen shows a warning sign, follow the guidance below.
Warning Sign
Cause
Try this
The bobbin winding button is pressed without
pushing the bobbin winder stopper to the left.
Push the bobbin winder stopper to
the left and press the bobbin
winding button.
Sew the basting stitch without lowering the feed dog.
The machine is started with the feed dog lowered.
Lower the feed dog and sew
basting stitch.
Raise the feed dog and start the
macine.
If a stitch for free hand quilting
has been selected, the warning
sign will disappear after a while.
to
… 66 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Memory Craft 6300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Memory Craft 6300 in the language / languages: English as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info