602026
18
Zoom out
Zoom in
Previous page
1/68
Next page
17
Winding the bobbin
For the bobbin winding, set the speed control lever at
the medium to high speed position.
[1] Hold the end of thread.
[2] Guide the thread through the thread guide “A”.
[3] Thread the thread guide “B”.
[4] Thread the thread guide “C”.
[5] Thread through the hole in the bobbin from the
inside to the outside.
1 Bobbin winder spindle
[6] Put the bobbin on the bobbin winder spindle, and
push it to the right.
2 Bobbin winder stopper
[7] Hold the free end of the thread in your hand and
depress the foot control.
Stop the machine when it has made a few turns,
and cut the thread close to the hole in the bobbin.
Depress the foot control again.
When the bobbin is fully wound, it will stop
automatiaclly.
, Return the bobbin winder to its original position by
moving the spindle to the left, and cut the thread as
shown.
* The machine will not sew until the spindle is in the
left position.
* You can also use the additional spool pin for the
bobbin winding as shown.
3 Spool
4 Additional spool pin
5 Felt
6 Additional spool pin hole
7 Spool base
[1]
[2]
[4]
[3]
[5]
[6]
[7]
,
3
5
4
7
6
1
6
2
“A”
“B”
“C”
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Memory Craft 4800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Memory Craft 4800 in the language / languages: English as an attachment in your email.

The manual is 2,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info