602026

Janome Memory Craft 4800 Manual

15
Zoom out
Zoom in
Previous page
1/68
Next page
14
[1] [2]
[3]
[1] [2]
[1] [2]
1
2
3
1
2
3
1
2
3
Changing Needles
[1]Raise the needle by pressing the Up/down needle
position key and lower the presser foot.
Turn off the power switch.
Loosen the needle clamp screw by turning it
counterclockwise.
Remove the needle from the clamp.
[2]Insert the new needle into the needle clamp with the
flat side to the rear.
When inserting the needle into the clamp, push it up
as far as it will go. Tighten the clamp screw firmly by
turning it clockwise.
[3]To check for a good needle, put the flat side of the
needle onto something flat (the needle plate, glass
etc.).
The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt
needle.
1 Needle clamp screw
2 Pin
3 Needle clamp
To Attach and Remove the Presser Foot
[1]Press the red button on the back of the foot holder.
The presser foot will drop off.
[2]Place the selected presser foot so the pin on the foot
lies just under the groove of the foot holder.
Lower the presser bar to lock the foot in place.
1 Red button
2 Groove
3 Pin
To Remove and Attach the Foot Holder
[1]To Remove:
Remove the thumb screw by turning the screw
counterclockwise with the screwdriver.
[2]To Attach:
Match the hole in the foot holder with the threaded
hole in the presser bar.
Fit the thumb screw into the hole.
Tighten the screw by turning it clockwise.
1 Thumb screw
2 Foot holder
3 Presser bar
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Memory Craft 4800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Memory Craft 4800 in the language / languages: English as an attachment in your email.

The manual is 2,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info