472828
23
Zoom out
Zoom in
Previous page
1/37
Next page
21
w
e
r
t
q
w
e
q
y
Button Sewing
Machine setting
q Stitch pattern: C
w Stitch width: Adjust as necessary
e Stitch length: Any
r Thread tension: 3 – 7
t Presser foot: Zigzag foot A
y Feed dog: Lowered
Unthread the needle. Adjust the stitch width to
match it with the span of the holes in the button.
Turn the handwheel to check if the needle enters
into each hole in the button.
Lower the foot to hold the button in place.
The holes in the button should align with the slot
of the foot.
A pin can be placed on the foot to form a shank.
Make sure to check if the needle enters into both
holes in the button.
q Pin
Re-thread the needle and sew about 10 stitches
and cut the needle and bobbin threads at the
beginning.
Raise the presser foot and remove the fabric. Cut
the needle and bobbin threads leaving 8˝ (20 cm)
tails.
Bring the needle thread between the button and
fabric through the holes in the button.
Pull the needle thread to pick bobbin thread up to
the right side of the fabric.
Wind the threads to from a shank and tie them
together.
w Needle thread
e Bobbin thread
NOTE:
Raise the feed dog after sewing.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Magnolia 7318 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Magnolia 7318 in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info