472826

Janome Decor Computer 2010 Manual

58
Zoom out
Zoom in
Previous page
1/86
Next page
58
Darning
Machine setting
q Pattern
w LED display
e Foot R: Automatic buttonhole foot
z Pull the button holder fully to the back.
x Draw the needle thread to the left through the hole
on the foot.
c Lower the needle into the fabric at starting point.
Lower the foot and depress the foot control.
The machine will darn and stop automatically. The
LED display will show a blinking dot when the
darning is finished.
NOTE:
The maximum length and width of the darning are
2 cm and 0.7cm respectively.
Sew another layer of darning over the previous one, at
the right angle.
q Button holder
w Starting point
e Maximum length (2 cm)
r Maximum width (0.7 cm)
t Blinking dot
qw e
z x c
q
w
e
r
v
aa
aa
a
y
u
ss
ss
s
(A) (B)
ss
ss
s Adjusting the evenness of the darning
Press the mode selection key to enter the stitch
length adjusting mode.
The LED display shows d5, which indicates the
neutral setting.
(A) If the left corner is lower than the right side,
press the Up (+) key to correct it.
(B) If the right corner is lower than the right side,
press the Down (–) key to correct it.
NOTE:
Allowable adjustment range is d1-d9.
aa
aa
a To sew a shorter darning
Sew the first row to the required length and press
the reverse stitch button. Continue to sew the
remaining stitches until the machine stops
automatically.
y Reverse stitch button
u Required length
t
… 58 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Decor Computer 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Decor Computer 2010 in the language / languages: English as an attachment in your email.

The manual is 2,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info