472832
24
Zoom out
Zoom in
Previous page
1/42
Next page
22
To sew
1Press the up/down needle button to raise the
needle.
Attach the automatic buttonhole foot R snapping
the pin into the groove of the footholder.
q Groove
w Pin
2 Pull the button holder to the back, and place
the button in it. Push it together tightly to the
button.
NOTE:
If the button is extremely thick, make a test
buttonhole on an extra piece of the fabric.
If it is difficult to fit the button through the test
buttonhole, you can lengthen the buttonhole by
pulling the button holder back a little. The length of
the buttonhole will be increased.
e Button Holder
r Extra gap
3 Pull the buttonhole lever down as far as it will go.
t Buttonhole Lever
4 Insert the corner of the fabric under the foot.
Press the up/down needle button twice.
Remove the fabric to the left to draw the needle
thread through the hole of the foot.
Place the garment under the foot, and lower the
needle at the starting point of the buttonhole
mark.
Then lower the automatic buttonhole foot R.
y Buttonhole Mark
u Starting Point
NOTE:
Make sure there is no gap between the slider and
stopper, otherwise the left and right lengths will be
different.
i Slider
o No gap
!0 Stopper
!1 Sewing gap
4
y
u
i
o
!0
!1
1
R
2
A
B
3
q
w
e
t
r
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome DC3050 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome DC3050 in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info