602047
88
Zoom out
Zoom in
Previous page
1/94
Next page
82
Problems and Warning Signals
When beep sounds and the LED display shows warning signal, follow the guidance below.
Audible signal
LED
Cause and Action
The foot control has been disconnected while sewing.
Turn OFF the power and connect the foot control.
A button is pressed when the machine halts due to the overload.
Wait for at least 15 seconds to recover.
If thread jamming causes overload, remove the tangled threads.
The Up (+) or Down (–) key is pressed after buttonhole is finished but the foot is not
raised.
Raise the foot.
Do not use the automatic buttonhole foot to sew any other pattern than buttonhole or
darning.
The machine is out of order.
Visual signal
BEEP Beep sounds when:
pip
pip-pip-pip
pip-pip-peep
peep
Normal operation
Invalid operation
Buttonhole is finished.
The machine is out of order.
88


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome DC2011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome DC2011 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info