602049
26
Zoom out
Zoom in
Previous page
1/52
Next page
24
9
0
Auto
1
2
3
05
4
Sewing on Buttons
Machine setting
Pattern #05
Foot F: Satin stitch foot
Thread tension Auto
Feed dog Dropped
Unthread the needle. Adjust the stitch width to match
the needle swing with the span of the holes on the
button, by pressing the plus (+) or minus (–) key.
Rethread the needle and lower the presser foot to
hold the button in place.
Turn the handwheel toward you to check if the needle
enters both left and right holes on the button.
Depress the foot control to sew 10 stitches and stop
the machine.
Raise the foot and draw out the fabric, and trim both
needle and bobbin threads at the beginning of stitches
but leaving 20 cm (8˝) tails at the end.
Pull the bobbin thread to pick the needle thread out to
the wrong side of the fabric and tie them together.
* After finish sewing, raise the feed dog by shifting the
drop feed lever to the original position.
1
2
3 4
5
1
2
3
4
1
2
3
4
5
6
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome 6260 QC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome 6260 QC in the language / languages: English as an attachment in your email.

The manual is 0,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info