652552

Jacob Jensen Smoke Alarm Optical JBXS03 Manual

17
Zoom out
Zoom in
Previous page
1/32
Next page
17
Alarm and volume
The alarm is activated when there is smoke in the detector. The alarm signal is
approximately 85dB/3m. The alarm signal is active as long as there is smoke in
the detector. When there is no longer smoke in the detector, the smoke alarm
will revert to stand-by / normal operation automatically.
Alarm signals
Acoustic signal
One short beep app. every minute indicates that the battery is weak and must
be replaced.
Two short beeps indicate malfunction due to background light or outer
interruptions of the smoke chamber.
Three short beeps indicate technical malfunctions.
Four short beeps indicate that the smoke alarm is dirty and must be cleaned.
A continuous sound indicates that there is smoke in the detector.
Visual signal
One flash every eighth seconds indicates normal operation.
Two flashes every eighth seconds indicate reduced sensitivity (pause function).
A continuous flash indicates smoke detection.
How to stop the alarm
One short beep app. every minute:
Replace the battery. (See further under "Replacement of battery”).
Two short beeps:
Remove the background light or outer interruptions which causes the
disturbance of the smoke alarms operation.
Three short beeps:
The smoke alarm needs to be tested.
Note: Modifying or tampering with the internal components of the smoke
alarm may cause malfunction and will invalidate the warranty.
Four short beeps:
Clean the smoke alarm. (See further under "Maintenance").
Continuous signals (both visual and acoustic):
Alarm for smoke detection / fire.
(The alarm will sound as long as there is smoke in the detector.
The alarm can be stopped by pressing the red test button.)
Mounting
The smoke alarm should be fitted using the enclosed
mounting bracket, which is to be mounted in the
ceiling with one screw only (screw and plug for 5 mm
drill enclosed – please use a special plug for plaster
ceilings).
When the bracket is fixed, the smoke alarm is attached with a click. It is now firm
but can be turned for adjustment around the point to which it is attached.
Replacement of battery
The mounting plate makes it easy to pull down the smoke alarm for cleaning and
for replacement of the battery. As an extra safety precaution, the smoke alarm
cannot be mounted without a battery. The smoke alarm requires one 9 VDC
battery, (included – mounted in the battery-compartment).
Please note: The smoke alarm normally operates up to 10 days from the first
indication of low battery.
Please note: At first time installation simply remove the plastic strip between the
terminals and the contact before mounting the smoke alarm.
Note: For optimal detection the smoke alarm should be installed in a suitable
location as described above.
After mounting and after every battery change, test the smoke alarm by pressing
the red test button until a penetrating, clear signal is heard. Make sure that
the red test button flashes every eighth second. When the alarm is set-off, a
penetrating, rapidly pulsating signal is given out (min. 85dB/3m). The alarm can
be stopped by pressing the red test button.
Maintenance
The following guidelines will help you care for the JACOB
JENSEN
TM
Smoke Alarm
so you can enjoy using it for many years.
1. Keep the smoke alarm dry at all times. If it becomes wet, wipe it dry
immediately and remove the batteries. Liquids can contain minerals that might
corrode the electric circuits.
2. Use and store the smoke alarm only under normal temperature. Temperature
extremes can shorten the life of electronic components, damage the battery
and distort or melt plastic parts.
3. Handle the smoke alarm gently and with care. If it is dropped, circuit boards
can be damaged, resulting in malfunction.
4. Keep the smoke alarm free from dust and dirt to avoid the premature wear of
parts.
5. Clean the smoke alarm by wiping with a soft cloth. Do not use aggressive
chemicals, cleaning solvents or strong detergents.
6. Use only fresh batteries of the required size and type. We recommend Alkaline/
Top Grade batteries only. Always remove old or weak batteries as they might
leak chemicals that will destroy the smoke alarm.
7. Modifying or tampering with the internal components of the smoke alarm may
cause malfunction and will invalidate the warranty.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jacob Jensen Smoke Alarm Optical JBXS03 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jacob Jensen Smoke Alarm Optical JBXS03 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian as an attachment in your email.

The manual is 1,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info