554920
2
Zoom out
Zoom in
Previous page
1/2
Next page
UC-6007/6014 receiver 2/2 MJQ51102
Indicators on the front housing of the receiver indicate the status of the
output channels
LEDs 1 to 7(14) Meaning
Off Channel is not used (no transmitter is enrolled)
Steady Green Channel has a transmitter enrolled, relay is off
Steady Red Relay is on (activated by the enrolled transmitter)
Flashing Green Communication with the enrolled transmitter is down
(Low battery in transmitter, radio interference etc.)
Flashing Red Enrollment mode (to enroll a transmitter)
Flashing Red
(rapidly)
Output is overloaded or short-circuited.
Control channel MODE
The receiver has a special control channel MODE to which a control
panel type JA-6x (PgX output) or RC-4x remote controls can be enrolled.
This channel can be used for remotely controlling the mode in which the
outputs will work.
If no transmitter is enrolled to the MODE channel, then outputs 1-7(14)
react in a normal way to signals from their corresponding thermostats.
If the control panel is enrolled and the PgX output is activated (indicator
MODE lit red) outputs 1-7(14) react in a normal way to signals from their
corresponding thermostats.
If the PgX output is deactivated (indicator MODE lit green), then outputs
1-7(14) ignore signals from thermostats. They only react to anti-frost
signals from a thermostat supporting this feature (e.g. TP-31).
Indicator MODE
Off Channel is not used - no transmitter is enrolled
(
receiver reacts to standard signals from thermostats)
S
teady Green Transmitter is enrolled – channel MODE is
d
eactivated, outputs 1-7(14) only react to the anti-frost
s
ignals from thermostats
S
teady Red
T
ransmitter is enrolled – channel MODE is activated,
o
utputs 1-7(14) react to standard signals from
t
hermostats
lashing Green Communication with the enrolled transmitter is down
(
Low battery in transmitter, radio interference etc.)
Use and Maintenance
All enrolled transmitters (thermostats and detectors) transmit regular
check signals. If the receiver does not receive the signal of an enrolled
transmitter for a certain period, it will indicate that communication with this
item is down (flashing green LED) and the corresponding output will turn off
.
One reason for the lost connection can be low batteries in the transmitter.
The average lifetime of a transmitter's batteries is about 1 year. Each
transmitter checks its battery conditions and signals in advance if the
batteries are reaching a critically low state (see the transmitter manual for
details).
Another reason for possible connection failure can be radio signal
interference in the operational band of the receiver. In such a case the
receiver will usually indicate loss of communication with a multiple
number of transmitters. In this situation, check if there is any non-
approved or faulty radio-communicating device within the range of the
receiver.
Outputs which have not been activated for 7 days will switch on for
5 minutes to protect connected devices, especially pumps which can be
damaged if they are not used for a long time.
Warning: the manufacturer is not responsible for any damage caused
by improper installation or any non-suitable use of this product.
Specification
Power supply: 230 V AC, 50Hz, protection class II
Consumption: 0.02 A stand-by; 0.2 A max.
Max. relay output load: 10 A / 230V
Voltage of outputs 1-7(14) and COM: 24V DC
Max. load of outputs 1-7(14): max. 0.4 A per single output and 1.7A
total for all outputs
Radio frequency: 433.9 MHz
Working range with JA-60 100 m (open area)
Working range with RC 30 m (open area)
Dimensions: 258 x 214 x 77 mm
Radio characteristics: ETSI EN 300220
EMC: EN 50130-4, EN 55022
Safety: EN 60950
Working temperature: -10 to +40
o
C
Can be operated according to ERC REC 70-03
Jablotron Ltd. hereby declares that the UC-6007/6014 is in
compliance with the essential requirements and other relevant provisions
of Directive 1999/5/EC. The original of the conformity assessment can be
found on website www.jablotron.com
-Technical support section.
Note: Although this product does not contain any harmful
materials we suggest you return the product to the dealer or
directly to the producer after use.
Dimensions
Internet: www.jablotron.cz
Tel.: +420 483 559 999
fax: +420 483 559 993
Pod Skalkou 33
466 01 Jablonec nad Nisou
Czech Republic
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron UC-6007 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron UC-6007 in the language / languages: English as an attachment in your email.

The manual is 0,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info