554923
2
Zoom out
Zoom in
Previous page
1/2
Next page
TP-89 digital bus thermostat 2 / 2 MKL51701
Note: Floor heat detection is of higher priority than room
temperature detection. This means that the current temperature in the
room is taken into account only when the current floor-temperature is
between FL Lo and FL Hi.
You can display the current floor temperature by entering the menu,
scrolling to the FL t parameter and pressing the knob (a re-press will
cause a return to the menu).
Displaying the set temperature
As mentioned above, normally the thermostat displays the current
temperature in the room. If you want to display the set temperature,
press the knob briefly (no matter if the thermostat is locked). The set
temperature will then flash on the display for 3 seconds.
Temperature
Parameter
setting
Locked
Heating on
Locking the thermostat
To prevent the accidental changing of the set temperature the
thermostat can be locked by pressing and holding the knob (the
key symbol will appear on the display for about 2 seconds).
To unlock the thermostat simply press and hold the turning knob
(the key symbol will disappear on the display for about 2 seconds).
Heating fault detection
If the temperature in the room drops below AL Lo the thermostat
sends signals to the receiver. This is responded to by the receiver by
switching on the FRE (freeze) output for 10 seconds.
This feature is especially suitable for detecting heating faults.
RESET
The RESET function allows you to reset the device to the factory
defaults listed in the table. You can perform a RESET by selecting Res
in the adjustment menu and pressing and holding the knob for 5
seconds.
Specification
Power supply: via the receiver digital bus
Temperature measurement: +6 to +40 ˚C
Temperature accuracy: adjustable: ± 0.1, ± 0.2 or ± 0.5 ˚C
Freeze alarm (panic transmission) temperature threshold: <AL Lo
configurable from –9°C to +20°C
Operational range: up to 200 m (twisted cable)
Floor sensor type TS-80
Operational temperature range: -10°C to + 70°C (low humidity)
Dimensions: 65 x 88 x 20 mm
Complies with:
EMC EN 50130-4, EN 55022
Jablotron Ltd. hereby declares that the TP-89 is in
compliance with the essential requirements and other
relevant provisions of Directive 2004/108/EC. The original of
the conformity assessment can be found on the web site
www.jablotron.com, Technical Support section.
Note: Although this product does not contain any harmful
materials we suggest you return the product to the dealer or
directly to the manufacturer after use.
20
65
32.5 32.5
88
25
44
19
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron TP-89 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron TP-89 in the language / languages: English as an attachment in your email.

The manual is 0,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info