631258

Jablotron JA-82Y GSM communicator Manual

6
Zoom out
Zoom in
Previous page
1/8
Next page
JA-82Y user manual - 6 - MLD51300
• Dial the GSM communicator number.
• The system will answer in 15 seconds. Listen to the voice menu introduction, the system asks you to
key in your access code
• On your phone keypad, enter a valid access code (user, master or service code). Listen to the answer
(current system state) and the system offers to change its status.
• You can press 9 to open keypad simulation mode; switching back to voice menu mode is not possible
dial again.
• From this moment on, the telephone keypad will work as a system keypad.
• System status is signalled in these ways:
o 1 beep = set (armed)
o 2 beeps = unset (disarmed)
o 3 beeps = programming mode
o siren sound = alarm
o voice message during a type of event = intruder alarm, tamper alarm, fault,..
• Any subsequent change to the system status is again indicated acoustically. For instance, after
unsetting the system, you will hear two beeps. (see above)
• You can operate devices X or Y via the phone keypad the same way as from a system keypad.
This means *81/*80 will control device X and *91/*90 will control device Y.
• To terminate the connection simply hang up. Connection is automatically terminated if there is
no entry within 60 seconds.
Note: Remote access from a landline is only possible from a phone using tone dialling (DTMF).
9. Remote control by dialling-in
With some limitations, the communicator allows you to operate the system by ringing the
communicator. This operation requires your phone number to have been pre-authorized by being
stored in the communicator memory
Notes:
• Dialling-in operation is not enabled for phones having hidden numbers.
• If you control by dialling-in without remote access privileges, the system performs the
command and establishes the connection, it’s for free.
• A phone which is pre-authorized for dialling-in remote control can also by used for normal
remote control – just let it ring until the control panel answers the call by voice menu.
Naturally, a pre-programmed function will be performed first.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron JA-82Y GSM communicator at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron JA-82Y GSM communicator in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Jablotron JA-82Y GSM communicator

Jablotron JA-82Y GSM communicator Installation Guide - English - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info