554916
5
Zoom out
Zoom in
Previous page
1/12
Next page
MLO51201 - 20 -
AZ-10S optical smoke detector
The detector reports fire hazards. It is
activated by the presence of smoke or an
abnormal temperature increase. Besides
sending a report to the system, it also
triggers its own siren during an alarm.
Screw the detector holder to the ceiling
Use the computer to enroll the detector to the system (see the Settings)
Connect the battery and twist the detector onto the holder
Wait until the detector LED indicator goes off (calibration is in progress)
Test the detector – see the Communication test chapter. Activate the detector by
pressing and holding its testing button.
Tips and specifications
The detector cannot be twisted onto the holder if no battery is connected.
Install the detector onto the ceiling in a place with good air circulation (i.e. avoid corners,
hollows, tops of inclined ceilings, etc.).
If the space (or ceiling) is divided by partitions which prevent free air movement, each
section should have its own detector.
The detector should not be installed close to ventilators, heaters, ventilation openings or in
dusty premises.
It is not recommended to install the detector close to cookers, hot plates or anywhere where
steam is produced.
A suitable place to install an optical smoke detector is a ceiling above the staircase in the
house.
Never test the detector with fire; use a special spray designed for smoke detector testing to
simulate fire.
When an alarm is indicated, the siren can be switched off by pressing and holding the test
button.
The detector siren can be disconnected completely – by disconnecting its cable connector
(near the negative pole of the battery).
If people smoke in the room during normal operation, you can program Azor to react only
when set – see the Settings. In such a case disconnect the siren in the detector as well. Do
not forget to ventilate the premises before setting the alarm.
All jumpers in the detector must remain disconnected.
Battery-low signalling
When the detector battery is low, Azor sends an informative message. Besides that, the
smoke detector flashes and beeps approx. every 45 s.
- 5 - MLO51201
AZ-10D RFID tag reader
Serves for setting and unsetting. It is usually installed at the entrance door.
AZ-10M door-opening detector
Reports opening doors, windows, etc.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron Azor GSM Mini at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron Azor GSM Mini in the language / languages: English as an attachment in your email.

The manual is 0,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Jablotron Azor GSM Mini

Jablotron Azor GSM Mini User Manual - English - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info