803711
115
Zoom out
Zoom in
Previous page
1/140
Next page
115
Lubrication
All the pivoting points of the front and rear derailleurs should be
lubricated with light oil at least every month. Be sure to wipe off any
excess oil to prevent attraction of dirt into the mechanisms. The shifting
cables should be cleaned and re-coated with a thin layer of grease every
six months, or whenever new cables are being installed.
Adjustment - Rear Derailleur
The Low limit screw determines how far the rear derailleur will travel toward the
wheel of the bicycle, while the High limit screw determines how far the cage will
travel toward the frame.
Shift the rear shifter to the largest number indicated, disconnect the rear 1. derailleur cable from the cable anchor bolt and place the chain on the
smallest sprocket.
Adjust the High limit screw so the chain and the smallest sprocket are 2. lined up vertically. Remove any slack in the cable by pulling it taut, then re-
connect the cable and tighten the cable anchor bolt securely.
Shift up through the gears making sure that each gear is achieved quietly and 3. without hesitation. If noise occurs, use the barrel adjuster to fine-tune the cable
tension. Turning the barrel adjuster clockwise will decrease cable tension
and allow the derailleur cage to move farther away from the bicycle in small
increments. Turning counter-clockwise will increase cable tension and bring
the cage closer to the bicycle. This will micro-adjust the positioning of the
derailleur cage in relation to the freewheel. Simply put; turn the barrel adjuster
the direction you want the chain to go.
Shift the chain onto the largest sprocket; adjust the low limit screw so the chain 4. and the largest cog are lined up vertically. If you are unable to get the chain to
the largest cog, turning the Low limit screw counter-clockwise will enable the
chain to move towards the wheel.
Shift through the gears ensuring each gear is achieved quietly and without 5. hesitation.
NOTE: It may take several adjustments to achieve the desired positioning.
Please refer to the troubleshooting section for more assistance.
Rear Derailleur Rear View
Freewheel
SIS Cable Adjuster
Top Gear
Pulley Adjustment
Screw
Guide Pulley
Tension Pulley
Adjustment
Screws
Rear Derailleur Side View
SIS Cable
Adjuster
High Gear
Adjustment Screw
Low Gear
Adjustment Screw
115


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Izip Enlightened Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Izip Enlightened Series in the language / languages: English as an attachment in your email.

The manual is 6.51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info