13
4.4 Charge/Recharge the Battery
1) Insert the charger into the charger socket; Be careful that only the original
charger is used and in 5 correct position.
2) Connect the electrical plug side of the charger into electric power plug.
3) When charging is complete, always disconnect from the electrical source and
then from the phone.
Notes:
1) When battery power is low and the phone cannot be turned on, keep
charging until the screen resumes indication of power.
2) Make sure that the standard voltage and power match the voltage and power
indicated on the charger.
3) During the charging/recharging period, it is best to keep phone turned off.
4) Use the battery only for its intended purpose. Never use any charger or
battery that is damaged or not original.
4.5 Use of Battery
Monitoring Battery Power
When the battery is low or nearly empty:
1) The screen displays battery low.
2) The empty battery icon blinks and the phone turns off.
Battery Power Reminder
1) If the battery is not used for long periods, fully charge the battery before use
again.
2) The battery can be charged and recharged hundreds of times, but it will
eventually wear out. When the talk and standby times are noticeably shorter
than normal, replace the battery.
3) If the battery is completely discharged, it may take many minutes before the
charging indicator appears on the display or before the phone can be used.
4) Your device is powered by a rechargeable battery. The full performance of a
new battery is achieved only after two or three complete charge and discharge
cycles.
4.6 Turn On or Off
1) Firmly press the End key until the phone powers on. The idle screen appears
in the display.
2) If phone lock password has been set, you will be requested to enter the PIN
numbers, then press the OK key to confirm.
3) If PIN code has been set, you will be requested to enter the PIN numbers,
then press the OK key to confirm.
4) To turn phone off: Firmly press the End key until phone turns off.
Note: The background screen appears when the phone is turned on and is in
standby mode.