5
USIM card.
Barring code
A barring code is required for setting the call barring function. You can obtain this code from the
network operator to set the call barring function.
4.3 Installing T-flash card
To install the T-flash card, open its latch, place its indented side downward, insert the card into the
card slot, and then close the latch.
Note: The mobile phone cannot automatically identify the T-flash card being inserted when the
mobile phone is powered on. You must power off the mobile phone and then power it on, so that
the phone can identify the T-flash card.
4.4 Charging the battery
The lithium battery delivered with the mobile phone can be put into use immediately after being
unpacked. Battery level indication:
Your mobile phone can monitor and display the battery state.
Normally the remaining energy of the battery is indicated by the battery level icon at the upper right
corner of the displayed screen.
When the battery energy is insufficient, the mobile phone prompts "battery low". If you have set an
alert tone, an alert tone will be given off when the battery level is too low.
4.5 Using a travel adapter
-Install the battery into the mobile phone before charging the battery.
-Connect the adapter of the travel charger with the charging slot in the mobile phone. Ensure that
the adapter is fully inserted.
-During the charging, the battery level grids in the battery icon keep flickering till the battery is fully
charged.
-Power off the mobile phone before removing the battery.
Note: to guarantee your personal safety and protect the environment, do not litter the battery!
Return the old battery to the mobile phone manufacturer or place it in specified battery reclamation
areas. Do not litter any battery with other rubbish.
Warning: short-circuits of the battery may cause explosion, fire, personal injury or other severe
consequences!
4.6 Power on/off the mobile phone
-Hold the end key for a while to power on the mobile phone. A power-on animation appears on the
display screen.
-Input the phone lock code and press the ok key if the mobile phone prompts you to input the
phone lock code. The original code is 0000.
-Input the PIN and press the ok key if the mobile phone prompts you to input the PIN. The PIN is
provided by the network operator for new opening USIM card.
5. Dialing calls
In the standby mode, press number keys to input the area code and the telephone number, and
then press the send key to dial a call. To end the call, press the end key.
5.1 Make a voice call
-Make a voice call in idle screen
1) In idle screen, press number key to input a phone number.
2) Press send key to make a call.
