318183

Irobot roomba pro elite Manual

6
Zoom out
Zoom in
Previous page
1/14
Next page
The Virtual Wall Units
The Virtual Wall Unit keeps Roomba in the room or area you want cleaned.It uses an invisible beam of light to block
13+ foot-wide open doorways or to close off other large areas.Use the Virtual Wall Unit to block open doorways or clean
one portion of a large room.Multiple Virtual Wall Units can be used to block off multiple doorways or open areas,or extra-
wide openings.The Roomba Pro and Pro Elite both come with two Virtual Wall Units.
Virtual Wall Unit Battery Installation
1. Open the Battery Door located on the bottom of each
unit by first loosening the screw (see Figure 9).
2. Insert 2 new “D”size alkaline batteries (not included)
in each unit by following the “+”and “-”symbols.
3. Replace the Battery Door and tighten the screw.
Figure 10a: Close-up of the Virtual Wall Unit.
Beam Emitter
Battery Door
Range
4-7
0-3 8+
Range Selector Switch
Power Button
Power Light
CAUTION:
To ensure proper function and avoid
battery leakage:
1. Always use alkaline batteries.
2. Do not mix old and new batteries.
3. Do not mix alkaline,standard or
rechargeable batteries.
4. Batteries should be installed by an adult.
5. Non-rechargeable batteries are not to
be recharged.
6. Rechargeable batteries are to be removed
from the product before being charged.
7. Only batteries of the same or equivalent
type as recommended are to be used.
8. Batteries are to be inserted with the
correct polarity.
9. Exhausted or dead batteries are to be
removed from the product.
10. The supply terminals are not to be
short circuited.
11. Remove batteries before storing.
"D"SIZE/LR20
1.5V
"D"SIZE/LR20
1.5V
Figure 9: Insert 2 “D”-size
alkaline batteries in the
bottom of each Virtual
Wall Unit.
Pausing and Stopping Roomba
Roomba can be paused temporarily during a cleaning cycle,then set back on the cleaning cycle where it left off.Roomba
may also be stopped at any time,at which point it will clear the current cleaning cycle to prepare for another.
Pausing Roomba in a Cleaning Cycle
To temporarily pause Roomba while it’s in a cleaning cycle simply pick it up by its handle,or press any button on Roomba
except the Power Button.The button corresponding to the cleaning cycle that Roomba has temporarily paused will flash.
(Note: If you are using the Roomba Remote,please see additional information in
The Roomba Remote on page 12.) Note
that Roomba will shut itself off,clearing its current cleaning cycle,if it is left paused for more than five minutes.
Spot Cleaning during a Cleaning Cycle
Roomba can clean a spot one or more times while it is paused in the middle of a cleaning cycle,then continue the cleaning
cycle afterward.To Spot Clean during a cleaning cycle,do the following:
1. Pause Roomba.
2. Press the Spot Button.Roomba will play its brief“Spot Cleaning”tune,then start cleaning a 3-foot-wide area.
3. After Roomba completes the Spot Cleaning Cycle (1-2 minutes),it will play it’s “Done Spot Cleaning”tune,and go back
to being paused.
Un-Pausing Roomba
To un-pause Roomba and continue it’s cleaning cycle,press any button on Roomba except the Power or Spot Button.
Roomba will play its brief “Back to the Cleaning Cycle”tune and start cleaning again where it left offin its cleaning cycle.
Stopping Roomba
To turn Roomba off,press the Power Button.
Hint: If Roomba is moving, you can press any button or lift Roomba up to pause it first before turning Roomba off.
To stop Roomba in order to start a new cleaning cycle,do one of the following:
1. Press the Power Button twice to turn Roomba off then on again.Roomba is now ready to start a fresh cleaning cycle.
Empty both sides of the Particle Bin,then press a desired Cleaning Cycle Button to start cleaning.
2. To start Roomba cleaning on a new cleaning cycle quickly,press and hold the desired new cleaning cycle button while
it’s cleaning, until you hear Roomba play its “Start Up”tune and start the new cleaning cycle.
10
11
Pro Elite Manual MECH.qxd 7/11/03 11:35 AM Page 11
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Irobot roomba pro elite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Irobot roomba pro elite in the language / languages: English as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info