632872
10
Zoom out
Zoom in
Previous page
1/16
Next page
10 iRobot Mirra 500 Series Owner’s Manual
4
1. Place the power supply (transformer) at least 3.6 meters / 11.8 feet
from the pool and atleast 12 cm / 4 Inch above the surface.
The transformer will supply low voltage to the cleaner.
2. Uncoil the cable.
4. Plug the cable into the power supply. Make sure the key on the plug corresponds
exactly with the key slot on the socket of the power supply.
(See details on the next page)
5. Plug the power supply into a grounded outlet. Ensure that the electric outlet has
been properly grounded.
6. Press the CLEAN button and the light will glow indicating that the system is
“ ON ” and the pool cleaner will start the cleaning cycle.
3. Place the unit in the water.
Turn the unit side to side
in the water to allow air to
escape from the body
and then let the cleaner
sink to the bottom of the
pool. Then, spread the cable
over thesurface of the pool
asevenly as possible.
Operating Your Pool Cleaner - Set Up
IMPORTANT:
Please be sure to always keep your pool cleaner properly stored anywhere
between 10 to 40 degrees Celsius (50 to 104 degrees Fahrenheit). This will
keep the motors, plastics and seals protected.
Robot can be used in water with temperatures ranging from 13°C to 35°C
(55°F to 95°F). However, the recommended optimal temperature is between
22°C and 32°C (72°F and 90°F)
1a
12 cm
(4.7 inch)
3.6m/11.8ft
1
2
3
4
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Irobot Mirra 500 Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Irobot Mirra 500 Series in the language / languages: English as an attachment in your email.

The manual is 1,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Irobot Mirra 500 Series

Irobot Mirra 500 Series User Manual - German - 16 pages

Irobot Mirra 500 Series User Manual - French - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info