22
Chapter 6 – Replacing Filters
Chapter 6 – Replacing Filters
The IQAir® system is equipped with a lter life monitor which is designed to assist you in determining when a lter
needs to be replaced. If the pollution load is high and the lter load indices are not set appropriately, there is a
possibility that the lter may not be effective throughout the displayed life time.
For this reason it is important to look out for the signs of used up lters. The main signs are:
•Increased operating noise
•Decreased airow
•Clogged lter
•Increased odour presence
6.1 Location of the Filter Elements
The IQAir® system features a modular housing design which enables easy replacement of all lters in a matter of
minutes. The illustration of the IQAir® system on the right side of the control panel shows the positions of the
individual lters. These positions correspond to the actual positions of the lters within the system.
5.3 Replacing the Battery of the Remote Control
When the battery becomes weak, the transmission results will deteriorate and
the battery should be replaced. The remote control requires one CR2025
battery. The battery compartment is located at the bottom end of the remote
control.
To open the battery compartment, press the small leaver to the side and slide
the battery compartment out. Remove the used battery and insert the new
battery.
6.2 Ordering Replacement Filters
Please order the replacement lter elements from your point of purchase by quoting the name and the article
number of the lter. Both can be found on the label of the individual lter element.
