19
Chapter 6 – Replacing Filters
Chapter 6 – Replacing Filters
The IQAir® system is equipped with a Filter Life Monitor which is designed to assist you in determining when a filter
needs to be replaced. If the air pollution in your environment is very high, there is a possibility that the filter may not
be effective throughout the displayed life time and may have to be replaced earlier than indicated by the Filter Life
Monitor.
For this reason, it is important to look out for the signs of used up filters and replace filters earlier if necessary. The
main signs are:
• Increased operating noise
• Decreased airflow
• Clogged filters
• Increased odor presence
6.1 Location of the Filter Elements
The IQAir® system features a modular housing design which enables easy
replacement of all filters in a matter of minutes.The illustration of the IQAir® system on
the control panel shows the positions of the individual filters. These positions
correspond to the actual positions of the filters within the system.
5.3 Replacing the Battery of the Remote Control
When the battery becomes weak, the transmission results will deteriorate and the
battery should be replaced.The remote control requires one CR2025 battery.The battery
compartment is located at the bottom end of the remote control.
To open the battery compartment, press the small lever to the side and slide the battery
compartment out. Remove the used battery and insert the new battery.
6.2 Ordering Replacement Filters
To order replacement filters, please contact your local IQAir authorized dealer. To locate the dealer nearest to you,
call 1-877-715-4-AIR (247) or visit www.iqair.us.
Please order your replacement filters by quoting the appropiate article numbers stated below:
IQAir® Dental Pro: Pre-Filter Art. No. 102 10 12 00
Gas phase filter cartridge set Art. No. 102 40 50 00
Poster-Filter sleeve set Art. No. 102 50 10 00
IQAir® Dental Hg: Pre-Filter Art. No. 102 10 12 00
Gas phase filter cartridge set Art. No. 102 40 12 00
Poster-Filter sleeve set Art. No. 102 50 10 00
