24
Chapter 8 – Anti-Tampering Kit Instructions
4) Reinsert the face plate
and press it in completely.
5) Insert the at-head
screwdriver into the small
opening on the side of the
display control panel.
4
5
6) Loosen and lift out the
control panel carefully. Do
not lift more than 2-3
inches.
7) Disconnect the ribbon
cable from the control
panel (at red connectors).
8) Insert two of the larger
types of screws (Torx 20)
into the two holes and
tighten, using the supplied
tool.
7
8
6
9) Plug the red connector
of the ribbon cable back
into the control panel.
Ensure that it is pushed in
all the way.
10) Tuck the ribbon cable
underneath and reinsert
the control panel into its
holder. Snap into place.
11) When you reconnect
the air cleaner to a wall
outlet, the control panel
should again display
information. If not, the
control panel is not
connected properly. Re-
check steps 5-10.
10
11
9
Now the other side.
Now you have secured the air cleaner in order that it may not be opened by an unauthorized person. For lter
replacement you will need to remove the four arm locking screws. (Refer to diagram 3 and 8).
