744564
23
Zoom out
Zoom in
Previous page
1/44
Next page
Energy Distribution 2015 23
4. Ensure that the baffle pieces are pushed together
at the center joint.
CAUTION - Do not force the baffle pieces. Gently
adjust the baffle orientation until each side can be
removed freely from the stove.
GLASS REPLACEMENT PROCEDURES
WARNING : DO NOT OPERATE THIS APPLIANCE WITH
THE GLASS PANEL REMOVED, CRACKED, OR
BROKEN. DO NOT SUBJECT THE DOOR TO ABUSE,
SUCH AS STRIKING OR SLAMMING SHUT. ONLY A
QUALIFIED SERVICE PERSON SHOULD REPLACE
THE GLASS PANEL.
1. Follow the instructions included with the replacement
glass kit.
2. Remove the screws from the glass clips (use
penetrating oil if necessary) Set aside for
3.
4. reinstallation.
5. Carefully lift the damaged glass off the door and
discard.
6. Remove any remaining glass and old gasket
material.
7. Clean the screw holes and place a small amount
of anti-seize compound in each one.
8. Install a new glass gasket in the glass gasket
groove.
9. Place the new glass onto the door.
10. Important! Center the glass and ensure that the
edges of the glass are parallel with the edges of
the opening.
11. Check glass position again (centered, and
parallel), then screw the glass retainer clips with
the glass pads back on the door using a crisscross
pattern. Tighten the screws no more than 1/8
th
of
a turn after they seat. The glass will break at this
point if not positioned correctly.
12. Apply a light film of anti-seize lubricant on the
door’s hinge pins if needed.
13. After 5 or 6 fires, check the glass retainer screws,
and retighten if necessary. Use only 4mm x
329mm x 395mm Ceramic, or
Neoceram glass. Contact your INVICTA dealer.
CREOSOTE FORMATION & REMOVAL
When wood burns slowly at low temperatures, it
may produce tar and other organic vapors, which
combine with expelled moisture to form creosote.
These creosote vapors condense in the relatively
cool chimney flue of a slow-burning fire. As a
result, creosote residue accumulates on the flue
lining. When ignited, this creosote makes an
Figure 20: Front Door assembly
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Invicta Itaya at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Invicta Itaya in the language / languages: English as an attachment in your email.

The manual is 9,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info