509750

Inverto IDL7000m SCI Manual

9
Zoom out
Zoom in
Previous page
1/87
Next page
1.2. Connection to main power supply
After all the connections are done you can connect your digital receiver to the main power. Just before plugging a power cable into the
wall connector put the power switch, on the rear panel (17), in position 0.
1.3. Switching on your receiver
Switch the power switch, (17) on the rear panel, to the position “I”.
The satellite receiver is now switched on and starting (the message “Booting up” is shown on the display). This can take around 20
seconds. From now on, you can switch your receiver on or to standby using the “Standby” key on the remote control or on the front
panel of the receiver.
Note:
Behaviour of the receiver after switching on or power up depends on the “Power-up Mode” settings (see chapter 4.1.1.11 Power Up
Mode)
1.4. Starting the unit for the first time:
When you install your receiver for the fi rst time or when you do a factory
reset, you will enter in the fi rst installation mode. The unit will ask you to go
through the following steps to setup the unit for proper operation (to record
and watch services):
Step1: after the fi rst power up or factory reset (in user menu):
The quick start guide menu displayed:
Select your country:
press “select”, then “up/down” keys of your remote control to select the •
country,
then press again to validate your choice•
Select your language:•
press “select”, then “up/down” keys of your remote control to select the •
country,
then press again to validate your choice•
Once your selections are OK, press Exit on the remote control.
Step2:
A new menu is displayed: User Preferences
In general, you do not need to modify the settings in this display.
If you want to set up specifi c settings, then modify the lines according to
your preferred settings, using the remote control.
Once your selections are OK, press Exit on the remote control.
Step3:
Signal strength and signal quality bars
In two level bar meters, on the right side of the screen, the user can see
the strength and quality of the signal coming from the antenna dish to
the tuners. These two meters can be used while doing a fi ne-tuning of
the antenna position. The antenna has to be adjusted to have maximum
possible signal strength and signal quality.
8
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inverto IDL7000m SCI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inverto IDL7000m SCI in the language / languages: English, Swedish, Finnish as an attachment in your email.

The manual is 2,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info